Cub Cadet 7000 Series manual Accessing the Engine Compartment, General Battery Information

Page 33

ACCESSING THE ENGINE COMPARTMENT

WARNING: If the tractor has been recently operated, engine surfaces (including the radiator) will be HOT. Allow the engine to cool before open- ing the hood, or use extreme caution to avoid burns when the hood is open.

To raise the hood, locate the latch release lever in the hood notch at the front of the tractor. Lift and hold the latch release lever while lifting the hood at the hood notch. See Figure 34.

Fully raise the hood so that the hood prop cylinders hold the hood in the raised position.

HOOD

NOTCH

Lift Hood

LATCH

 

RELEASE

Lift Lever

LEVER

 

Figure 34

To remove the two side panels:

Flip the tabs of the two quick release fasteners up and turn to align with the slots in the side panel. See Figure 35.

Pivot the top of the side panel over and off the quick fastener tabs.

Pivot the top of the side panel until the two tabs at the bottom of the panel can be withdrawn from the slots of the side panel mounting brack- ets; then remove the side panel. See Figure 35.

To reinstall the side panels:

Insert the two side panel tabs into the slots of the side panel mounting brackets. See Figure 35.

Pivot the top of the panel toward the tractor and over the tabs of the quick release fasteners.

Pull the quick fastener tabs slightly outward and rotate 1/4 turn (perpendicular to slot) to lock the side panels in place. Flip the fastener tabs down.

QUICK FASTENER

Pivot

Flip up

Turn

QUICK

FASTENER

SIDE

PANEL

SIDE PANEL

TABS IN MTG.

BRKT. SLOTS

Figure 35

Close the hood by pushing downward until captured by the hood latch.

GENERAL BATTERY INFORMATION

WARNING:

Battery posts, terminals and related accesso- ries contain lead and lead compounds. Wash hands after handling.

Should battery acid accidentally splatter into the eyes or onto the skin, rinse the affected area immediately with clean cold water. If there is any further discomfort, seek prompt medical attention.

If acid spills on clothing, first dilute it with clean water, then neutralize with a solution of ammonia/water or baking soda/water.

NEVER connect (or disconnect) battery charger clips to the battery while the charger is turned on, as it can cause sparks.

Keep all sources of ignition (cigarettes, matches, lighters) away from the battery. The hydrogen gas generated during charging can be combustible.

As a further precaution, only charge the battery in a well ventilated area.

Always shield eyes and protect skin and clothing when working near batteries.

WARNING: Batteries contain sulfuric acid and may emit explosive gases. Use extreme caution when handling batteries. Keep batteries out of the reach of children.

33

Image 33
Contents 184VSHYGXW%OXMIRKIWIPPWGLEJX¤7EEVFVµGOIR¤+IVQER English Français Deutsch Table of Contents Calling Service InformationTo the Owner Recording Model and Serial Number Information Tractor Model PlateRops Information Plate Using the Tractor Correctly General Operation Important Safe Operation PracticesChildren Slope OperationOperating the PTO Do notService Safety Frame RopsSymbols on the appliance Safety Labels FAN Warning Label Located on Each Side of RadiatorStarting AID Located Under Hood Battery Warning Label Located Under Hood PTO Warning Label Located on Rear PTO ShieldRoll Over Warning Label Located on RIGHT/REAR Fender Floorboard and Dash Panel Mounted Controls Controls and FeaturesIgnition Switch PTO SwitchSeat Adjustment Lever Steering WheelHeadlight Switch Hazard Light SwitchDifferential Lock Pedal Parking Brake LeverEngine Coolant Temperature Light Battery Indicator LightParking Brake Indicator Light PTO Indicator LightPTO Reverse Override Switch Fender Mounted Conrtols and FeaturesFuel Fill Cap PTO Selection LeverCup Holder Transmission Hi/Lo Range Shift LeverHand Holds Amber Hazard LightsOperation Rollover Protective Structure RopsFolding the Rops Safety Interlock System NEW Tractor BREAK-IN ProceduresFueling the Tractor Starting the Engine Using Jumper Cables to Start EngineCold Weather Starting Stopping the EngineDriving the Tractor Using the FORWARD/REVERSE PedalDriving on Slopes Stopping the TractorUsing the HI/LO Range Shift Lever Using the Differential Lock PedalLOW Using the Hydraulic Lift Lever Using the PTO Selection LeverEngaging the PTO Using the TOP Link Retainer Hook Using the PTO Reverse Override SwitchHazard Lights LightingUsing the Hitch Plate Using the Three Point HitchUsing the Auxiliary Hydraulic Valve Using the Auxiliary Hydraulic Control HandleOn Demand Four Wheel Drive Tractor WeightingAdjusting the Seat AdjustmentsAdjusting the Seat Belt Three Point Hitch AdjustmentsCheck the TOE-IN AS Follows Adjusting Front Wheel TOE-INAdjusting Hydraulic Lift Feedback ROD Adjusting the BrakesMaintenance Lubrication TableGeneral Information Lubrication and Maintenance Chart Illustration Service Intervals Operation to Lubrication and Maintenance ChartGeneral Battery Information Accessing the Engine CompartmentCharging the Battery Battery RemovalBattery Maintenance Battery StorageHead Light Bulb Replacement Hazard Bulb ReplacementTail Light Bulb Replacement Servicing Electrical System Accessing the Fuse CenterInstrument Panel Fuses RelaysChecking TRANSMISSION/HYDRAULIC System OIL Level Hazard Light Flasher RelayChanging TRANSMISSION/HYDRAULIC System OIL Initial Break-In Period Filter ChangeCheck Front Axle Oil Regularly Scheduled Oil Filter ChangesChanging Front Axle and Final Reduction Gear Case OIL Check Final Reduction Gear Case OilTire Maintenance Maintenance of the Rollover Protective Structure RopsLubrication of Main Drive Shaft Lubrication of FWD Drive ShaftRemoving the Tractor from Storage Tractor StorageCleaning the Engine Engine MaintenanceCleaning RADIATOR/RADIATOR Screen Checking Engine OIL LevelChanging the Engine OIL and Filter Adding Engine OILChecking Engine Coolant Level Changing the AIR Cleaner Inspection of Cooling System HosesChanging the Engine Coolant Servicing the Fuel Filter Draining The Fuel FilterChanging The Fuel Filter Fuel Injector Nozzle Service Engine Breather ServiceSpecifications Optional Equipment and Accessories HOW to Obtain Service 073URGXFWV$NWLHQJHVHOOVFKDIW

7000 Series specifications

The Cub Cadet 7000 Series is a line of premium lawn tractors designed for homeowners who seek both performance and durability in their gardening equipment. With a robust build quality and innovative features, the 7000 Series enhances the mowing experience, making it efficient and enjoyable.

One of the standout features of the 7000 Series is its powerful engine options. Equipped with Kohler and Kawasaki twin-cylinder engines, these tractors offer impressive horsepower that translates into higher mowing speeds and superior cutting performance. The engines are designed to provide reliable starting and increased torque, making them suitable for tackling thick grass and uneven terrain.

The series also highlights a superior cutting system. With a 48 to 54-inch cutting deck, the 7000 Series provides a precise and clean cut, allowing users to achieve a manicured lawn. The cutting decks are constructed with durable materials and feature a reinforced edge, ensuring longevity and resistance to wear over time. The decks come with adjustable cutting heights, giving users the flexibility to choose the perfect height for their lawn conditions.

Incorporating advanced technology, the Cub Cadet 7000 Series features a premium hydrostatic transmission. This system offers smooth and effortless speed control and allows for seamless transitions between forward and reverse. The intuitive controls facilitate maneuverability, making it easy for users to navigate around obstacles in their yard.

Comfort and convenience are paramount in the design of the 7000 Series. The tractors come equipped with fully adjustable, high-back ergonomic seats that provide excellent support during extended mowing sessions. Additionally, the dashboard is designed with maximized visibility, offering users clear insights into the tractor's operations and available features.

To enhance productivity, the 7000 Series is compatible with a range of accessories, including mulch kits, baggers, and snow removal attachments. These attachments increase the versatility of the tractors, allowing users to efficiently manage seasonal tasks beyond mowing.

In conclusion, the Cub Cadet 7000 Series combines power, durability, and convenience, making it a top choice for homeowners seeking a high-performance lawn tractor. With impressive cutting capabilities, advanced technologies, and ergonomic design, this series is well-suited for anyone looking to maintain their lawn with ease and efficiency. Whether for regular mowing or seasonal yard work, the 7000 Series stands out as a reliable and practical choice.