Cub Cadet 48-inch/54-inch/60-inch/72-inch service manual OIL Chart, If Mower is so equipped

Page 26

.

OIL CHART

Apply a few drops of engine oil or use a spray lubricant. Apply the oil to both sides of pivot points. Wipe off any excess. Start engine and operate mower briefly to insure that oil spreads evenly.

Number of Oil Points

Description

DAILY
4	Deck Suspension Pivots
4	Height Adjustment Turnbuckle Clevis Pin
2	Height Adjustment Handle Pivots
2	Height Adjustment Stop Pivots
2	Deck Lift Linkage Pivots
2	Transport Handle Pivots
1	Transport Handle Pin
2	Deck Frame Up-and-Down Pivots

WEEKLY

1Seat Hinge

2Steering Lever Linkage Rod End Bearings

2	Lever Return Assembly Rod End Bearings
2	Pump Control Lever Pivots
1	Brake Lever Pivot Clevis Pin
1	Brake Lever Control Rod Pivot
1	Brake Control Rod Swivel Joint
4	Brake Rod Clevis Pins
2	Brake Shaft Assembly Pivots

2Grass Collection System Lid Hinges

(If Mower is so equipped)

LUBRICATION CHART

Use a grease-gun filled with NO. 2 Multipurpose Lithium Base Grease

No. of Grease Fittings

Description

EVERY 25 HOURS
3	Blade Spindle Bearings
WEEKLY
2	Front Caster Wheels
2	Front Caster Wheel Spindles
4	Mowing Deck Pivots
2	Deck Take-Up Idler Pivots
1	Axle Pivot
2	Steering Lever Pivots
1	Hydro Take-up Idler Pivot
1	Park Brake Pivot
2	Mower Deck Ball Wheels

26

Image 26

Contents Hydrostatic Zero-Turn Commercial Riding Mower Table of Contents Forward General General Safety OperationsSafety Precautions Related to Batteries When MowingRelated to Fuel Towing Operator Protection System -FoldableSuspension Seat Safety Decals and Labels Shield Missing do not OperateSpecifications When Mowing Operating InstructionsSafety Awareness when Mowing To Mow Grass and Produce a Striped PatternFigure Fuel Shutoff Valve Initial Adjustments Check the fluid levels and tiresOrientation Zero Turn Break-In And Operating ProceduresLubricate all fittings listed in the mainte- nance section Initial OperationPage Parking the Mower Mower Cutting BladesStart the Engine Removing the Mower Deck Maintenance ServiceMower Deck Changing a Blade Changing the Spindle AssemblyHydraulic Oil Sharpening a BladeAdding Hydraulic Oil use Rimula SAE15W40 Stop the engine and remove the key from the ignition switchElectrical Circuit Draining Hydraulic OilSpecific Gravity Freezing Temp F Battery RemovalInstalling the Battery Jump StartingTires Inflation PressureBrakes Hydraulic Oil Tank and FilterPage To Put the Mower Back in Service StorageMaintenance Schedule OIL Chart If Mower is so equippedHigh Speed Tracking Adjustment Engine RPM Check and AdjustmentLap Bar Adjustment Deck Corner Ball Wheel Roller SettingsDeck Center Anti-Scalp Roller Settings Deck leveling Procedure Wiring Diagram Page U.S.A Canada