Cub Cadet 48-inch/54-inch/60-inch/72-inch General Safety Operations, Safety Precautions

Page 4

GENERAL SAFETY

OPERATIONS

A.DANGER

1.Do not operate machine in confined areas where exhaust gases can accumulate.

2.Do not operate machine without mower chute deflector in place and operational.

3.Do not carry passengers.

B.WARNING

1.Do not operate machines under the influence of alcohol or drugs.

2.Do not operate machines without all guards and safety devices in place and functional.

3.Do not start machines if there are fuel or oil leaks or spillage — clean it up.

4.Do not operate machines near spilled or leak- ing fuels.

5.Do not stop or park machine over dry leaves, grass, debris, etc. that could be combustible.

6.Use extreme care when backing up.

7.Do not operate machine on slopes greater than 15 degrees (27%).

8.Do not operate machines on slopes when traction is reduced (wet grass, ice, soft ground, loose ground, leaves, pine needles, debris, etc.).

9.Avoid turning downhill if possible, go slowly and use extra care when turning downhill.

10.Do not operate machines during reduce visi- bility (low light, fog, rain, etc.).

11.Do not operate machines with non-approved attachments.

12.Do not operate machines that are dam- aged.....have machine repaired.

13.Do not operate machines that have not been properly maintained.

14.Use only replacement parts that are the same or equivalent to the original equipment.

15.Do not modify machines or any of their com- ponents, especially the engine governor!

16.Do not operate machine for more than 2 hours without hearing protection.

C.CAUTION

1.Use proper protective equipment when oper- ating machine (gloves, boots, and hearing protection are recommended).

2.Read entire machine Operator’s Manual.

3.Make sure operators are fully trained in the safe use of the machine.

4.Follow all safety instructions when using the machine.

5.Keep all safety signs legible and properly installed.

6.Do not check for hydraulic leaks with any part of the body.

7.Do not add fuel to a machine when the engine is running and/or the exhaust system is hot.

8.Keep machine clean and free of debris, grass, leaves, oil, grease, etc.

9.Place lap bars in neutral/start position, set park brake, disengage P.T.O., turn engine off, and remove ignition key before you dismount from machine.

10.Use machines laterally or diagonally across slopes, avoid going downhill when possible.

11.Go slowly and use extra care when descend- ing slopes.

12.Disengage P.T.O. when crossing surfaces such as asphalt, concrete, loose ground, sand, gravel, etc.

13.Use extra care when loading and unloading machines from trucks or trailers.

SAFETY PRECAUTIONS

A.General

1.Read this Operator’s Manual before starting the mower. Study the controls and learn the proper sequence of operation.

2.Do not allow anyone to operate or maintain this machine who has not read this manual. Never permit children to operate this machine.

3.Never carry passengers.

4.Do not remove any shields, guards or safety devices. If a shield, guard or safety device is damaged or does not function, repair or replace it before operating the mower.

5.Always wear safety glasses and safety shoes when operating or maintaining this mower. Do not wear loose-fitting clothing.

6.Disconnect the spark plug wires and remove the key from the ignition to prevent the engine from accidentally starting before performing any maintenance on this mower.

7.Never run the engine indoors without ade- quate ventilation. Exhaust fumes are deadly.

8.To avoid serious burns, do not touch the engine, exhaust pipe or muffler while the engine is running or until it has cooled after it has been shut off.

9.The liquid in the battery is dilute sulfuric acid. Always wear safety glasses and rubber gloves when working on the battery. Do not overfill the battery.

10.Lead-acid batteries generate hydrogen and oxygen gases which form an explosive mix- ture. Keep sparks and flames away at all times.

4

Image 4
Contents Hydrostatic Zero-Turn Commercial Riding Mower Table of Contents Forward Safety Precautions General Safety OperationsGeneral Related to Fuel When MowingRelated to Batteries Towing Operator Protection System -FoldableSuspension Seat Safety Decals and Labels Shield Missing do not OperateSpecifications When Mowing Operating InstructionsSafety Awareness when Mowing To Mow Grass and Produce a Striped PatternFigure Fuel Shutoff Valve Initial Adjustments Check the fluid levels and tiresZero Turn Break-In And Operating Procedures Lubricate all fittings listed in the mainte- nance sectionOrientation Initial OperationPage Start the Engine Mower Cutting BladesParking the Mower Mower Deck Maintenance ServiceRemoving the Mower Deck Changing the Spindle Assembly Hydraulic OilChanging a Blade Sharpening a BladeStop the engine and remove the key from the ignition switch Electrical CircuitAdding Hydraulic Oil use Rimula SAE15W40 Draining Hydraulic OilBattery Removal Installing the BatterySpecific Gravity Freezing Temp F Jump StartingTires Inflation PressureBrakes Hydraulic Oil Tank and FilterPage To Put the Mower Back in Service StorageMaintenance Schedule OIL Chart If Mower is so equippedHigh Speed Tracking Adjustment Engine RPM Check and AdjustmentDeck Center Anti-Scalp Roller Settings Deck Corner Ball Wheel Roller SettingsLap Bar Adjustment Deck leveling Procedure Wiring Diagram Page U.S.A Canada