Frigidaire FREEZER/REFRIGERATOR GLASS DOOR REFRIGERATOR Electrical Information, Other Precautions

Electrical Information

These guidelines must be followed to ensure that safety mechanisms in the design of this appliance will operate properly.

Avoid fire hazard or electric shock. Do not use an extension cord or an adapter plug. Do not remove any prong from the power cord.

•Refer to the serial plate for correct electrical rating. The power cord of the appliance is equipped with a three-prong grounding plug for protection against shock hazards. It must be plugged directly into its own properly grounded three-prong receptacle, protected with a 15 amp time delay fuse or circuit breaker. The receptacle must be installed in accordance with the local codes and ordinances. Consult a qualified electrician. Receptacles with Ground Fault Circuit Interrupters (GFCI) are

NOT RECOMMENDED. DO NOT USE AN EXTENSION

CORD OR AN ADAPTER PLUG.

•If the voltage varies by 10 percent or more, appliance performance may be affected. Operating the appliance with insufficient power can damage the motor. Such damage is not covered under the warranty. If you suspect your voltage is high or low, consult your power company for testing.

•To prevent the appliance from being turned off accidentally, do not plug the unit into an outlet controlled by a wall switch or pull cord.

•DO NOT pinch, knot, or bend the power cord in any manner.

Other Precautions

•NEVER unplug the appliance by pulling on the power cord. Always grip the plug firmly and pull straight out from the receptacle.

•To avoid electrical shock, unplug the appliance before cleaning.

NOTE: Turning the control to “OFF” turns off the compressor but does not disconnect power to other electrical components.

Installation and Setup

Inspection for Damage

Inspect the underside of the cabinet and packaging for damage such as a fork truck can cause. If hidden damage is found after uncrating, immediately call the delivery carrier and request an inspection. Retain all packaging and crating materials until the inspection is complete.

Uncrating and Set-up

•Remove carton and all loose parts from inside of the unit.

•Tip the unit onto its back with the help of one assistant. Lay the unit gently to rest on blocks to avoid damaging the condensate drain hose, and the plastic raceway that covers the evaporator tubing on the back of the cabinet.

•Remove and discard the two (2) wood skids from the bottom and the four (4) screws (see the Fig. 1).

•Remove the bottom door hinge and screw on the lower left hand side of the cabinet used to support the glass door during shipping using a 3/8 socket wrench (see Fig. 2).

•Remove the package containing the casters from the unit. This package will contain the following items:

•Two (2) caster rail supports (A)

•Two (2) spacer plates (B)

•Eight (8) carriage bolts (C)

•Four (4) bolts (D)

•Four (4) washers (E)

•Eight (8) locking nuts (F)

•Two (2) swivel casters (G)

•Two (2) fixed casters with brakes (H)

Figure 1

Figure 2

3