Cub Cadet 48-inch/54-inch/60-inch/72-inch service manual Operating Instructions, When Mowing

Page 10

OPERATING INSTRUCTIONS

 

Figure. 1

Engine throttle

Ignition Switch

Choke Lever

Electric Blade

Tach and

Clutch Switch

Hour Meter

A.General

1.When Mowing:

a.Keep adults, children, and pets away from the area to be mowed.

b.When operating this mower, in the forward direction, do not allow the steering levers to return to Neutral on their own. Always maintain a firm grip on the levers, operate them smoothly and avoid any sudden movements of the levers when starting and stopping.

c.If the mower is equipped for side dis- charge, never use the mower without the discharge chute installed and placed in the down position.

d.Always remove debris and other objects from the area to be mowed (Note: debris and loose grass will reduce traction).

e.Mow only in daylight.

f.Watch for holes, sprinkler heads, and other hidden hazards.

g.Avoid driving too close to trees, creeks, ditches, sand traps, and other obstacles.

h.Before backing up, check behind and watch where you are going.

i.Always reduce speed when making a turn, and when grass is wet.

j.Always mow across slopes, never up and down the slope. Do not operate on steep slopes and slow down before turning.

Avoid turning downhill if possible, start at the bottom and work up to the top. Use extra care and go slowly when turning downhill. Control the speed and direction of the zero turn machine “primarily” with the speed/directional control (lap bar) of the downhill side of the machine...I.E.,

Figure. 2

Parking Brake

maintain the uphill side lap bar “essen- tially” in a fixed position.

k.Be careful when crossing gravel paths or roadways. Always turn off the blade clutch switch and wait until the blades stop rotat- ing and raise the cutting deck to the trans- port position. Always allow other vehicles to have the right of way.

l.If you hit a solid object while mowing, turn off the blade clutch switch, place the steer- ing levers in the neutral position, move the throttle to slow, set the parking brake, shut off the engine, and take the key from the ignition switch. Inspect for damage. Repair the damage. Make sure the blades are in good condition and that the blade bolts are tight before restarting the engine.

m.Never leave the mower unattended without observing the following: turn off the blade clutch switch, placing the steering levers in the neutral position, moving the throttle to slow, setting the parking brake, shutting off the engine and taking the key from the igni- tion switch.

n.Never walk or stand on the discharge side of the mower when the engine is running. Turn off the blade clutch switch if another person approaches while you are operat- ing the mower.

o.Never attempt to operate the traction unit without having the mowing deck attached.

p.Keep the mower and especially the engine and hydraulic components clean and free

10

Image 10
Contents Hydrostatic Zero-Turn Commercial Riding Mower Table of Contents Forward Safety Precautions General Safety OperationsGeneral Related to Fuel When MowingRelated to Batteries Towing Operator Protection System -FoldableSuspension Seat Safety Decals and Labels Shield Missing do not OperateSpecifications When Mowing Operating InstructionsSafety Awareness when Mowing To Mow Grass and Produce a Striped PatternFigure Fuel Shutoff Valve Initial Adjustments Check the fluid levels and tiresOrientation Zero Turn Break-In And Operating ProceduresLubricate all fittings listed in the mainte- nance section Initial OperationPage Start the Engine Mower Cutting BladesParking the Mower Mower Deck Maintenance ServiceRemoving the Mower Deck Changing a Blade Changing the Spindle AssemblyHydraulic Oil Sharpening a BladeAdding Hydraulic Oil use Rimula SAE15W40 Stop the engine and remove the key from the ignition switchElectrical Circuit Draining Hydraulic OilSpecific Gravity Freezing Temp F Battery RemovalInstalling the Battery Jump StartingTires Inflation PressureBrakes Hydraulic Oil Tank and FilterPage To Put the Mower Back in Service StorageMaintenance Schedule OIL Chart If Mower is so equippedHigh Speed Tracking Adjustment Engine RPM Check and AdjustmentDeck Center Anti-Scalp Roller Settings Deck Corner Ball Wheel Roller SettingsLap Bar Adjustment Deck leveling Procedure Wiring Diagram Page U.S.A Canada