Cub Cadet 5264D manual Accessing the Lower Dash Panel Area, Electrical Circuit Relays, Right Side

Page 31

Accessing the Lower Dash Panel Area

Some electrical components are housed inside the lower dash panel. To access the area, remove the dash panel insert by removing the two screws. See Figure 39.

SCREWS

DASH

PANEL

INSERT

Figure 39

To reinstall the dash panel insert, hook the retaining lip at the bottom of the insert over the bottom edge of the dash opening, pivot the insert upward into position, and secure with the two screws.

Electrical Circuit Relays

Several relays, which operate electrical functions of the tractor, are located inside the lower dash panel. If one of the circuits is not functioning properly, have your dealer electrically check the relay. See Figure 40.

 

Right Side

START

 

RELAY

 

PTO

 

RELAY

 

Left Side

CRUISE

 

CONTROL

 

RELAY

 

(OPTIONAL)

 

REVERSE

 

OVERRIDE

 

RELAY

 

REVERSE

 

RELAY

Figure 40

Start Relay — Functions in the start circuit.

PTO Relay — Operates in conjunction with both the Reverse Relay and Reverse Override Relay to engage the PTO.

Reverse Relay — Functions with the PTO Relay and Reverse Switch in the "No Cut in Reverse" circuit.

Reverse Override Relay — Functions with the Reverse Override Switch and PTO Relay to maintain PTO engagement when driving in reverse.

Cruise Control Relay — This relay is installed at the factory for use with the optional Cruise Control Kit. The relay functions in the cruise control circuit, when the kit is installed.

Hazard Light Flasher Relay

The flasher relay, which controls the on/off flashing of the hazard lights, is located inside the lower dash panel.

Replace the relay as follows:

Pull the wire harness from the right side of the dash opening and remove the electrical tape from the flasher relay. See Figure 41.

FLASHER

RELAY

TAPE

WIRE

HARNESS

HARNESS

LEADS

Figure 41

Note the position of the two harness leads, then disconnect the leads and replace the faulty relay with a new relay. Secure the relay to the wire harness with electrical tape.

Position the wire harness in the dash panel and reinstall the dash panel insert.

31

Image 31
Contents Operator’s Manual Important Read Safety Rules and Instructions CarefullyCalling Service Information Table of ContentsTo the Owner Rops Information Plate Recording Model and Serial Number InformationGeneral Operation Important Safe Operation PracticesDo not Slope OperationOperating the PTO Safety Frame RopsService ChildrenPage PTO Warning Label Located on Rear PTO Shield Safety LabelsBattery Warning Label Located Under Hood FAN Warning Label Located on Each Side of RadiatorControls and Features Throttle Handle PTO SwitchIgnition Switch Steering WheelTransmission 4WD Shift Lever Seat Adjustment LeverPTO Reverse Override Switch Hand HoldsFoldable Rops Rollover Protective Structure Hazard Light SwitchHeadlight Switch Differential Lock PedalBrake Engaged Indicator Battery Indicator LightOil Pressure Indicator PTO Engaged IndicatorFolding the Rops Safety Interlock SystemOperation Rollover Protective Structure RopsFueling the Tractor NEW Tractor BREAK-IN ProceduresStarting the Engine Driving the Tractor Using Jumper Cables to Start EngineCold Weather Starting below 14 F Stopping the EngineStopping the Tractor Using the Forward and Reverse PedalsUsing the HI/LO Range Shift Lever LOWUsing the 4WD Shift Lever Using the Differential Lock PedalDriving on Slopes Lighting Using the Hydraulic Lift LeverUsing the PTO Reverse Override Switch Engaging the PTORemoving the Rear PTO Cover Using the TOP Link Retainer HookUsing the Three Point Hitch Hazard LightsWeighting the Rear of the Tractor Using the Hitch PlateTractor Weighting Front WeightsThree Point Hitch Adjustments AdjustmentsAdjusting the Seat Adjusting the Seat BeltCheck the TOE-IN AS Follows Adjusting Front Wheel TOE-INAdjusting the Brakes Lubrication Table MaintenanceGeneral Information Lubrication and Maintenance Chart Illustration Service Intervals Operation to Lubrication and Maintenance ChartGeneral Battery Information Accessing the Engine CompartmentBattery Storage Battery RemovalCharging the Battery Battery MaintenanceNever use a higher amperage fuse Azard Bulb ReplacementServicing Electrical System Main FuseLeft Side Accessing the Lower Dash Panel AreaElectrical Circuit Relays Right SideHydraulic System Filter Part No Checking TRANSMISSION/HYDRAULIC System OIL LevelChanging the Hydro Transmission and Hydraulic System OIL Changing Hydraulic System FilterCheck Final Reduction Gear Case Oil Check Front Axle OilChanging Front Axle and Final Reduction Gear Case OIL Lubrication of FWD Drive Shaft Lubrication of Drive ShaftWheel LUG NUT Torque Maintenance of the Rollover Protective Structure Rops Tire MaintenanceRemoving the Tractor from Storage Tractor StorageDaihatsu Emission Control Defects Warranty Coverage Engine Information and MaintenanceIgnition System Adding Engine OIL Engine Maintenance Cleaning the EngineCleaning the Radiator SCREEN/RADIATOR Checking Engine OIL LevelChanging the Engine OIL and Filter Inspection of Cooling System Hoses Checking Engine Coolant LevelChanging the Engine Coolant Changing the AIR Cleaner Draining The Fuel Filter Servicing the Fuel FilterChanging The Fuel Filter Specifications Brakes Power Take-OffGeneral Dimensions Hydraulic Lift SystemDescription Model Number Optional Equipment and AccessoriesU.S.A Canada