Cub Cadet 23HP Electrical Circuit, Specific Gravity Freezing Temp F, Battery Removal

Page 17

drain oil from both left and right axles. Replace and retighten nuts.

Transmission

Figure. 9

j.Coat new filter seal with oil before installa- tion. Install new hydraulic oil filter filled with new oil.

k.Add proper amount of hydraulic oil to res- ervoir.

l.Run and purge gearboxes. Check oil level.

m.Add proper amount of hydraulic oil to res- ervoir and repeat step L.

C.Electrical Circuit

Danger:

Read General Safety Precautions Nos. 9 and 10.

1.Battery: The battery is located beneath the operator’s seat. Remove the fillcaps and check the level of the liquid electrolyte in the battery every 50 operating hours. If the level in any of the six cells has dropped below the bottom of the split ring inside the fill hole, refill the cell with distilled water. To keep the out- side of the battery clean, brush on a strong solution of bicarbonate of soda and water and rinse with clean water. Keep the contacts and cable ends clean with a wire brush and make sure the connections are tight. Coat the termi- nals with petroleum jelly to prevent corrosion.

2.Battery Storage: When storing the Mower for long periods of time the following guidelines should be taken.

a.Disconnect the battery cables from the ter- minals and remove the battery. You will have to remove the control panel to access the battery strap. Replace control panel.

b.Clean the battery before storing. A dirty battery will lose its charge over time.

c.Store the battery with a full charge. A dis- charged battery will freeze (refer to the table below)..

Specific Gravity

Freezing Temp (°F)

 

 

1.265

-71

 

 

1.250

-62

 

 

1.200

-16

 

 

1.150

5

 

 

1.100

16

 

 

d.Recharge battery when ever the specific gravity value is less than 1.225

3.Battery Removal

Warning:

When removing the cables from the battery follow these steps to avoid a short between the wrench and the frame.

a.Remove the Negative (black) cable.

b.Remove the Positive (red) cable.

c.Release the hold down straps.

d.Remove the battery without tipping.

4.Installing the Battery

Note: The battery is delivered from the fac- tory fully charged and filled with electrolyte.

a.Attach the Positive (red) cable.

b.Attach the Negative (black) cable.

c.Attach the rubber battery strap.

5.Jump Starting

Warning:

Failure to use this starting procedure can cause sparking, and the gases in the battery to explode.

a.Attach the end of the red jumper cable to the Positive terminal (+) of the charged battery.

b.Attach the other end of the red jumper cable to the Positive terminal (+) of the low charge battery.

c.Attach the end of the black jumper cable to the Negative terminal of the charged bat- tery.

d.Attach the other end of the black jumper cable to the frame of the unit with the low charge battery.

6.Fuses: There is one fuse located in the wiring between the ignition and start switch and

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Hydrostatic Zero-Turn Riding Mower Table of Contents Forward General General Safety OperationsSafety Precautions Related to Fuel When MowingShield Missing do not Operate Safety Decals and LabelsSpecifications Operating Instructions When MowingSafety Awareness when Mowing To Mow Grass and Produce a Striped Pat- tern Figure Fuel Shutoff Valve Check the fluid levels and tires Initial AdjustmentsLubricate all fittings listed in the mainte- nance section Zero Turn Break-In And Operating ProceduresOrientation Initial OperationStart the Engine Mower Deck Maintenance ServiceParking the Mower Removing the Mower DeckChanging the Blade Drive Belts Changing a BladeStop the engine and remove the key from the ignition switch Changing the Spindle AssemblyHydraulic Oil Adding Hydraulic Oil use SAE20WInstalling the Battery Battery RemovalElectrical Circuit Specific Gravity Freezing Temp FPage Inflation Pressure TiresBrakes Hydraulic Oil Tank and Filter Hydraulic SystemStorage Maintenance Schedule If Mower is so equipped OIL ChartEnginge RPM Check and Adjustment High Speed Tracking AdjustmentLap Bar Adjustment Deck Corner Ball Wheel Roller SettingsDeck Center Anti-Scalp Roller Settings Deck leveling Procedure Wiring Diagram Equipment TWO-YEAR Limited Warranty

23HP specifications

The Cub Cadet 23HP lawn tractor is a powerful and efficient machine designed for homeowners looking to maintain their lawns with ease. This lawn tractor offers a blend of performance, comfort, and innovation, making it a top choice for both small and medium-sized yards.

At the heart of the Cub Cadet 23HP is its reliable engine. The 23 horsepower engine provides ample power to tackle tough mowing conditions and hilly terrains effortlessly. The engine is designed for optimal performance, ensuring that the tractor operates smoothly under various conditions. With a reliable starter system, getting the tractor running is quick and efficient, allowing users to get to work without delay.

One of the standout features of the Cub Cadet 23HP is its innovative cutting deck. The 46-inch or 54-inch cutting deck options are designed for precision and efficiency, providing an excellent cut quality while reducing the time spent mowing. The deck is equipped with adjustable cutting heights, allowing users to customize their lawn care to match their specific needs. This adaptability ensures that the mower can handle different grass types and lengths with ease.

Comfort is another key characteristic of the Cub Cadet 23HP. The tractor features an adjustable high-back seat that provides support during long mowing sessions. Its ergonomic design ensures that users can maintain a natural posture while operating the tractor, reducing fatigue. The steering wheel is also designed for ease of use, allowing for smooth maneuverability even in tight spaces.

In terms of technology, the Cub Cadet 23HP comes equipped with advanced features that improve user experience. The LED headlights provide excellent visibility for early morning or late evening mowing. Additionally, the tractor features a dashboard with clear gauges that keep users informed about fuel levels, engine temperature, and other essential metrics.

Safety is a priority with the Cub Cadet 23HP. The tractor is equipped with safety features such as a seat switch that ensures the mower stops when the operator leaves the seat. This feature reduces the risk of accidents and enhances overall safety during operation.

Overall, the Cub Cadet 23HP lawn tractor combines power, comfort, and cutting-edge technology to deliver an exceptional mowing experience. Whether you have a small backyard or a larger property, this lawn tractor is designed to meet a variety of landscaping needs efficiently, making lawn care a hassle-free task. With its robust build and thoughtful features, the Cub Cadet 23HP is an investment in maintaining a beautiful lawn.
Top Page Image Contents