Cub Cadet 8404 manual Operating the PTO, Safety Frame Rops, Service

Page 8

4. OPERATING THE PTO

Disengage the PTO, stop the engine, and wait until all moving components have completely stopped before dismounting the tractor and connecting, disconnecting, adjusting, cleaning, or servicing any PTO driven equipment.

Do not wear loose fitting clothing when operating the PTO or when near rotating equipment.

Keep the PTO shaft cover in place at all times. Replace the PTO shaft cap when the shaft is not in use.

When operating stationary PTO driven equip- ment, always apply the tractor parking brake and place chocks behind and in front of the rear wheels. Stay clear of all rotating parts.

5. SAFETY FRAME (ROPS)

Your tractor is equipped with a rollover protective structure (ROPS) which must be maintained in a fully functional condition. Use care when driving through doorways or spaces with a low overhead.

Never modify the ROPS in any way.

Never attempt to straighten or reweld any part of the main frame or retaining brackets that have been damaged. Doing so may weaken the structure and endanger your safety.

Never secure any parts on the main frame or attach the safety frame with anything other than the special fasteners specified.

Never attach ropes, chains, or cables to the ROPS for pulling purposes.

Although the ROPS provides you the maximum protection possible, never take unnecessary risks.

6. SERVICE

Use extreme care in handling fuels. They are extremely flammable and the vapors are explosive. Use only an approved container.

Never remove fuel cap or add fuel with the engine running.

Replace fuel cap securely and wipe off any spilled fuel before starting the engine as it may cause a fire or explosion.

Do not smoke when working around the battery or when refueling. Keep all sparks and flames away from the battery and fuel tank. The battery presents an explosive hazard because it gives off hydrogen and oxygen... especially when recharging.

Never store the fuel container or machine inside where there is an open flame or spark, such as a gas hot water heater, space heater or furnace.

The cooling system is under pressure. Never remove the radiator cap when the system is hot. Slowly turn the cap the to the first stop to release pressure before removing the cap. If the tractor has a coolant recovery tank, add coolant there instead of to the radiator.

Escaping hydraulic fluid under pressure can penetrate the skin. If fluid is injected into the skin, seek immediate medical attention. Do not use your hand to check for leaks. Use a piece of cardboard or paper.

8

Image 8
Contents Important Read Safety Rules and Instructions Carefully Operator’s ManualTo the Owner Table of ContentsCalling Service Information Recording Model and Serial Number Information Tractor Model PlateEngine Information Transmission InformationImportant Safe Operation Practices General OperationPage Page Do not Slope OperationChildren Operating the PTO Safety Frame RopsService Page Safety Labels Safety Labels Ignition Switch Controls and FeaturesSwitches and Dash Mounted Controls Light Switch Turn Signal SwitchHazard Lamp Switch PTO SwitchInstrument Panel Forward/Reverse Shift LeverHand Throttle Lever Tachometer Hourmeter Brake Pedals Right and Left Floor Board and Fender Mounted ControlsClutch Pedal Foot Throttle Main Shift LeverHi-Lo Range Shift Lever Auxiliary Hydraulics LeverBrake Pedal Lock Differential Lock PedalHydraulic Control Levers Mid PTO Lever Seat Adjustment LeverPTO Safety Switch Operation Rollover Protective Structure RopsPRE-STARTING Checks Fueling the TractorNEW Tractor BREAK-IN Procedures Starting the EngineStopping the Engine Driving the TractorStopping the Tractor Driving on Roadways Turning the TractorDriving on Slopes Check While Operating Travel SpeedsUsing the Position Control and Draft Control Levers Using the Differential LockUsing the Front Wheel Drive Using the MID PTO Using the DrawbarGround Penetration w/Draft Control and Position Surface Penetration w/Draft Control OnlyUsing the Three Point Hitch Top LinkLifting Rods Check LinksUsing Remote Hydraulics Tractor WeightingAdjustments Adjusting the SeatAdjusting Front Wheel TOE-IN Adjusting Front AxleBrake Adjustment Adjusting the FAN Belt TensionClutch Adjustment To Adjust Adjusting the Micro Switch HeightAdjusting Rear Wheel Tread Width Checking Steering Wheel General Information MaintenanceLubrication Table Lubrication and Maintenance Chart Service Intervals Operation toAccessing the Engine Compartment Fuel SystemChecking the Fuel Lines Bleeding the Fuel SystemServicing the Fuel Filter Adding Engine Oil Engine OIL and OIL FilterChecking the Engine Oil Level Changing Engine Oil and Filter Changing the Transmission Oil and Filter Transmission OIL and OIL FilterChecking the Transmission Oil Level Servicing the Front Axle Checking the Front Axle Oil LeverAdding Front Axle Oil Changing the Front Axle OilServicing the AIR Cleaner Draining the Clutch HousingChecking and Adding Coolant Checking and Cleaning Radiator ScreenServicing the Cooling System Lubricating the Tractor Changing the CoolantChecking the Radiator Hoses Brake pedal shaft both sides. See Figure Servicing the Battery General Battery InformationBattery Removal Battery MaintenanceRe-charging the Battery Battery StorageServicing the Electrical System Fuses Fuse BoxTire Maintenance Main Slow Blow FuseTractor Storage When Engine is Difficult To Start TroubleshootingEngine Troubleshooting When Output Is Insufficient When Color of Exhaust Is Especially BadWhen Engine Suddenly Stops When the Engine Must Be Stopped ImmediatelyTractor Troubleshooting When Tractor Does Not Move While Engine Is RunningBattery Troubleshooting Condition of Battery Cause CountermeasuresSpecifications ModelPTO CUB Cadet LLC Post Office BOX CLEVELAND, Ohio