Cub Cadet GT 3200 warranty Stopping The Engine, Driving The Tractor, Setting The Cruise Control

Page 16

continuously for more than 10 seconds at a time. If the engine does not start within this time, turn the key to “STOP” and wait a minute to allow the engine’s starter motor to cool. Try again after waiting.

•After the engine starts, slowly release the brake pedal. As the engine warms up, gradually pull the choke lever all the way back. Do not use the choke to enrich the fuel mixture, except when necessary to start the engine.

Stopping The Engine

NOTE: Remove the key from the ignition switch to prevent accidental starting or battery discharge if the equipment is left unattended.

•Place the PTO switch in the “OFF” position. Place the throttle control lever between the “MID” and “FAST” positions. Then turn the ignition key to the “STOP” position and remove the key from the ignition switch.

Driving The Tractor

WARNING: Avoid sudden starts, excessive speed and sudden stops.

WARNING: Do not leave the seat of the tractor with- out disengaging the PTO and engaging the parking brake. If leaving the tractor unattended, turn the ignition key off and remove key.

•Depress the brake pedal to release the parking brake and let the pedal up. Move the throttle lever to the position where the engine operates best for the load to be handled (normally full throttle).

NOTE: Do not use the forward or reverse control pedals to change the direction of travel when the tractor is in

motion. Use the brake pedal to bring the tractor to a stop before depressing either the forward or reverse control pedal.

•To move forward, slowly depress the forward control pedal until the desired speed is achieved.

•To move in reverse, check that the area behind is clear then slowly depress the reverse control pedal. Always look down and behind before and while backing up.

Setting The Cruise Control

NOTE: The cruise control feature can only be operated in the forward direction.

•Slowly depress the forward control pedal until the desired speed is achieved.

•Lightly push the cruise control lever downward.

•While continuing to hold the cruise lever down, lift your foot from the forward control pedal (you should feel the cruise latch engage).

•If properly engaged, the cruise lever and forward control pedal should lock in the down position, and the tractor will maintain the same forward speed.

•Disengage the cruise control using one of the following methods:

-Depress the brake pedal to disengage the cruise control and stop the tractor.

-Lightly depress the forward control pedal.

NOTE: Although not recommended, depressing the reverse pedal will also disengage the cruise control.

To change to the reverse direction when operating with cruise control, depress the brake pedal to disengage the cruise control and stop the tractor; then depress the reverse control pedal.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents OPERATOR’S Manual Series 3000 Tractor Model GTTable of Contents To the OwnerImportant Safe Operation Practices When you see this symbol. Heed ITS WarningGeneral Operation Never carry passengers Slope OperationDo Not Do not use a grass catcher on steep slopesChildren Be alert and turn machine off if a child enters the areaService General ServiceTowing Safe Handling of GasolineNever tamper with factory setting of engine governor Do Not Modify EngineSpark Arrestor Average Useful LifeSlope Guide Sight and hold this level with a vertical treeTractor Preparation Deck Front Lift Rod AssemblyPosition the High Back Seat Controls and Features Low Fuel Indicator Lamp Indicator Panel/Hour MeterSteering Wheel LCD Hour Meter DisplayIndicator Light Key Switch ModuleButton PTO Switch 12V Power OutletSeat Adjustment Lever Parking Brake Lever Forward PedalLower Raise Safety Interlock Switches OperationChoke Lever Starting The EngineStopping The Engine Setting The Cruise ControlDriving The Tractor Using the Hydraulic Lift System Driving On SlopesStopping The Tractor Auxiliary HydraulicsUsing the Reverse Caution Mode key position Reverse Caution ModeEngaging Differential Lock Using The DrawbarMowing Adjustments and Maintenance Checking Transmission Oil Level Operating Transmission Range Oil Fill Tube DipstickBattery Storage Battery MaintenanceTire Inflation Maintenance Chart Operation toBe performed Grease front wheel bearingsLubrication Illustration Service General Battery InformationBattery Removal Charging the BatteryHeadlight Bulb Replacement Adding Transmission Oil Dipstick must be installedAll times when the engine is Securely into the fill tube atChanging Transmission Oil Adjusting the Brake Electrical BoxFuse Front Wheel AlignmentHex Shaped Flange Hex Nylon Lock Nut AssemblyChanging the Engine Oil and Filter If using a fuel stabilizer Off-Season StorageMANUFACTURER’S Warranty Coverage OWNER’S Warranty ResponsibilitiesEngine Information CoverageMaintenance and Repairs Requirements LimitationsChecking Engine Oil Level Cleaning The EngineAdding Engine Oil Changing Engine Oil Sparkplugs Changing Air CleanerChanging Fuel Filter Servicing The Paper Element Servicing The PrecleanerServicing Oil Cooler Trouble Shooting Lack of PowerHard To Start Engine Operates Irregularly or KnocksOptional Equipment Description Model NumberSpecifications TiresBrakes Oil Filter Cartridge Crank Case CapacityReplacement Parts PRE-CLEANERDescription Part Number CartridgeGeneral Emissions Warranty Coverage Warranted Parts GDOC-100092 REV. a U.S.A Canada Transportation charges and service callsMTD Products Limited, Kitchener, on N2G 4J1, Phone
Related manuals
Manual 48 pages 30.97 Kb

GT 3200 specifications

The Cub Cadet GT 3200 is a powerful garden tractor that combines robust performance with innovative technology, making it ideal for homeowners and landscapers alike. This formidable machine is equipped with a heavy-duty Kohler engine, offering a variety of horsepower options to meet diverse needs. Whether used for mowing large lawns or tackling tough garden tasks, the GT 3200 proves to be a reliable workhorse.

One of the highlights of the GT 3200 is its Hydrostatic transmission, which provides seamless speed control without the need for manual gear shifting. This feature allows operators to easily navigate varying terrains, ensuring smooth operation in both forward and reverse. The precision steering system enhances maneuverability, making it easier to negotiate tight spaces and garden beds.

The GT 3200 boasts a cutting deck available in various sizes, including 48-inch and 54-inch options. This adaptability enables users to choose the size that best fits their mowing requirements. The deck is designed for efficiency, with dual-blade construction that delivers a clean, even cut across different grass types and terrain. Additionally, the deck’s adjustable cutting height allows for customized results, catering to users' specific aesthetic preferences.

Another notable characteristic of the Cub Cadet GT 3200 is its modular design, which allows for easy attachment of various implements. This versatility makes the GT 3200 suitable for multiple tasks, from mowing to snow clearing or tilling, as it can be equipped with a range of attachments such as snow blowers, front blades, and garden tillers.

Cub Cadet has integrated advanced technology in the GT 3200, including a digital gauge cluster that provides vital information at a glance, such as fuel levels and engine performance metrics. This technology enhances user experience and helps operators maintain optimal performance.

In terms of comfort, the GT 3200 comes with an ergonomic seat and intuitive controls, ensuring that operators can work for extended periods without discomfort. The high-back seat provides excellent support, and the easy-to-reach controls simplify operation, making mowing and gardening tasks less strenuous.

In summary, the Cub Cadet GT 3200 is a versatile, powerful, and technologically advanced garden tractor that offers a wide range of features designed to enhance performance and user experience. Whether for comprehensive lawn care or diverse landscaping tasks, the GT 3200 stands out as a top choice for those seeking quality and reliability in outdoor equipment.
Top Page Image Contents