TO DRAINOIL
Drain oil while engine is warm. Followthe instructions given below.
•Drain the gas tank, start the engine and let it run until the fuel line and carburetor are empty.
•Remove oil fill dipstick.
•Tip unit on its side to drain through the oil fill tube.
•When engine is drained of all oil, refill with approximately 20 oz. of fresh oil. Refer to Gas And Oil
•Replace dipstick.
SERVICEAIRCLEANER
The air cleaner prevents damaging dirt, dust, etc., from entering the carburetor and being forced into the engine and is important to engine life and performance. The air cleaner consists of a foam filter. Never run the engine without an air cleaner completely assembled.
To ServiceAir Cleaner:
•Remove foam filter from plastic housing on top of engine.
•Wash in water and detergent solution, and squeeze (do not twist) until all dirt is removed.
•Rinse thoroughly in clear water.
•Wrap in a clean cloth and squeeze (do not twist) until completely dry, or allow to air dry.
•Saturate with engine oil and squeeze to distribute oil and remove excess oil.
•Replace foam filter in plastic housing
NOTE: If the foam filter is torn or damaged in any way, replace it.
WARNING:muffler and WARNING:nearby areasTemperaturemay exceedof
150 ° F(65°C). Avoid these areas.
SERVICESPARKPLUG
•Clean the spark plug and reset the gap to .030" at least once a season or every 50 hours of operation. See Figure 10. Spark plug replacement is recommended at the start of each season. Refer to engine parts list for correct spark plug type.
NOTE: Do not sandblast spark plug. Spark plug should be cleaned by scraping or wire brushing and washing with a commercial solvent.
.030" Feeler Gau
Figure 10
SERVICEMUFFLER
•Inspect muffler periodically, and replace if necessary.
•If your engine is equipped with a spark arrester screen assembly, remove after every 50 hours of use for cleaning and inspection. Replace if damaged.
Vacuum without a muffler or tamper with WARNING: Do not operate the Yard
the exhaust system. Damaged mufflers or spark arresters could create a fire hazard.
CLEANENGINE
•Clean engine by removing dirt and debris with a cloth or brush.
•Frequently remove grass clippings, dirt, and debris from cooling fins, air intake screen, levers, and linkage. This will help ensure adequate cooling and engine speed.
11