MAINTENANCE | _ | _ | ,_ | ||
SCHEDULE |
| _o_ | _¢_ _ |
| |
h- |
|
|
|
|
|
o | Lubrication |
|
| _ | |
0 | Clean equipment |
| _ | <_ | |
|
| ||||
| Check engine oil |
|
|
| |
,,, | Change | engine oil |
| _ | _ |
Z | Service | air cleaner |
|
|
|
|
|
|
| ||
Z
"' Service spark plug Service muffler
Clean engine
GENERALRECOMMENDATIONS
•Always observe safety rules when performing any maintenance.
•The warranty on this Yard Vacuum does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must maintain the equipment as instructed in this manual.
•Some adjustments will need to be made periodically to maintain your equipment properly.
•Follow the maintenance schedule.
•Periodically check all fasteners and make sure they are tight.
WARNING: Always stop the engine and
disconnect and ground the spark plug
wire before performing any maintenance
or adjustments.
_
<_
CLEANEQUIPMENT
•Clean the Yard Vacuum thoroughly after each
use.
•Wash the bag periodically with water. Allow to dry thoroughly in the shade.
•If the flail screen becomes clogged, remove and clean as instructedin the SERVICE AND
ADJUSTMENT section.
NOTE: Cleaning with a forceful spray of water is not recommended as it could contaminate the fuel
system.
CHECKENGINE01L
•Remove oil fill dipstick.
•Check oil level on dipstick. Level should be at FULL mark.
•Replace dipstick and tighten.
LUBRICATION
•Wheels- Place a few drops of SAE 30 oil on each shoulder screw once a season.
Refer to Figure 6.
•Nozzle height adjustment levers- Lubricate nozzle height adjustment levers with light oil. Refer to Figure 6.
•Locking Rod- Lubricate the lock rod and compression springs which attach to the mounting bracket. Refer to Figure 4.
CHANGEENGINEOIL
•Only use high quality detergent oil rated with API service classification SF, SG, or SH. Select the oil'sSAE viscosity grade according to the expected operating temperature. Refer to operation section for viscosity chart.
•Stop engine and wait several minutes before checking oil level. With engine on level ground, the oil must be to FULL mark on dipstick.
•Change engine oil after the first five hours of
operation, and every
10