Fuel Filter Change
Refer to the part breakdown on Page 27 for identi- fication of components in the following steps.
To change the fuel filter:
1.FOLLOW SHUTDOWN PROCEDURE AND ALLOW ENGINE TO COOL!
1.Drain the fuel tank by removing the fuel tank drain plug (Figure 25). Use a funnel and cer- tified fuel container to capture the fuel as it drains.
Hex Nuts
Fuel Tank Drain Plug
Fuel Valve
Figure 25. Fuel tank drain plug and fuel valve.
2.Remove the two hex nuts shown in Figure 25. These hex nuts hold both the fuel valve and the fuel filter in place.
3.Remove the fuel tank cap and extract the fuel filter through the top of the tank as shown in Figure 26.
H8191 3600 PSI Diesel Pressure Washer
Fuel Filter
Fuel Valve
Figure 26. Removing the fuel filter.
4.Insert a new filter, making sure the gasket at the base of the fuel filter and the gasket at the base of the fuel valve are in place.
5.Fasten the fuel valve nuts securely.
6.Fasten the fuel tank drain plug securely.
Note: If you have difficulty removing the fuel filter, you may find it easier with the fuel tank removed entirely. To do this, refer to the parts breakdown on Page 27, remove the upper and lower fuel lines, and remove the upper tank bracket. Once the tank is removed, the fuel filter can be removed and replaced more easily. Be sure to reattach and securely fas- ten any fuel lines or brackets you remove.