Applying Chemicals, To change nozzles

To change nozzles:

1.FOLLOW THE SHUTDOWN PROCEDURE ON PAGE 15!

2.Pull back the quick connect coupler on the end of the spray gun wand and remove the current nozzle.

3.Select a nozzle, pull back the quick connect coupler and insert the nozzle, as shown in Figure 9.

Figure 9. Inserting a nozzle.

4.Release the quick connect coupler, then twist and pull the nozzle to make sure it is secure in the coupler.

Always double-check coupler connections on all fittings. Improperly connected fittings can blow apart under pressure, causing severe personal injury or equipment damage.

NOTICE

Always try a nozzle on a small test area or piece of test material to determine if it is the correct nozzle for the task. Some nozzles provide so much pressure they can destroy even sturdy materials.

Nozzles

0° Red Nozzle

This nozzle delivers an extremely powerful pinpoint stream that covers a very small cleaning area.

15° Yellow Nozzle

This nozzle delivers a powerful 15° spray pattern for intense cleaning of small areas.

25° Green Nozzle

This nozzle delivers a 25° spray pattern for intense cleaning of larger areas.

40° White Nozzle

This nozzle delivers a 40° spray pattern and a less powerful stream of water. It covers a wide area of cleaning.

Chemical Black Nozzle

This nozzle is used to apply chemicals or cleaning solutions. It has the least powerful stream.

Applying Chemicals

Use only household detergents, cleaners, and degreasers recommended for use in pressure washers. NEVER use toxic or corrosive chemicals, acids, poisons, insecticides, or flammable solvents such as gasoline or kerosene with your pressure washer. Failure to follow this warning could result in machine failure, significant property damage, severe personal injury, or death.

Applying chemicals or cleaning solvents is a low pressure operation. Use only the chemical nozzle to apply chemicals or solvents.

-12-	H8191 3600 PSI Diesel Pressure Washer