Problem | Cause | Solution | |
|
|
| |
Packings are failing | Scored, damaged, or worn plungers | Install new plungers. | |
frequently or |
|
| |
Abrasive material in fluid being pumped | Install proper filtration on pump inlet plumbing. | ||
prematurely | |||
|
| ||
| Inlet water temperature too high | Check water temperature. It should not | |
|
| exceed 160_F (70_C). | |
| Overpressurizing pump | Do not modify any | |
|
|
| |
| Excessive pressure due to partially | Clean or replace tip. See Installing and | |
| plugged or damaged tip | Changing Spray Tips (page 12). | |
| Pump running too long without spraying | Never run pump more than 10 minutes without | |
|
| spraying. | |
| Running pump dry | Do not run pump without water. | |
|
|
| |
Strong surging at inlet | Foreign particles in inlet or discharge | Clean or replace valves. | |
and low pressure on | valve or worn inlet and/or discharge |
| |
discharge side | valves |
| |
|
|
| |
Water spitting out of | Pump running too long without spraying | Trigger gun to get fresh, cooler water in pump. | |
thermal valve |
|
| |
|
|
|
Note: For complete pump repair and design information see website: www.ARNORTHAMERICA.com
18309828