Husky HU80522 manual Adding OIL to the Engine, Adding Gasoline to the Fuel Tank, OIL CAP Dipstick

Page 10

ASSEMBLY

ADDING OIL TO THE ENGINE

See Figure 3.

NOTE: This machine has been shipped with approximately 2 oz. of oil in the engine from testing. You must add oil to the engine before starting it the first time.

CAUTION:

Any attempt to start the engine without adding oil will result in engine failure.

Place pressure washer on a flat, level surface.

Unscrew the oil cap / dipstick by turning counter- clockwise.

Using 4-stroke engine oil (SAE 30), fill to the upper level of the oil filter neck (18 oz., 4-cycle engine oil provided).

Replace the oil cap / dipstick and securely tighten.

NOTE: This engine has a total oil capacity of 20 oz. (.6 liters).

ADDING GASOLINE TO THE FUEL TANK

See Figure 4.

WARNING:

Gasoline and its vapors are highly flammable and explosive. To prevent serious personal injury and property damage, handle gasoline with care. Keep away from ignition sources, handle outdoors only, do not smoke while adding fuel, and wipe up spills immediately.

When adding gas to the pressure washer, make sure the unit is sitting on a flat, level surface. If the engine is hot, let the pressure washer cool before adding gas. ALWAYS fill the fuel tank outdoors with the machine turned off.

NOTE: Use unleaded gas only. DO NOT mix oil with gas.

Before removing the fuel cap, clean the area around it. Remove the fuel cap.

Insert a clean funnel into the fuel tank then slowly pour gasoline into the tank. Fill tank to approximately 1-1/2 in. below the top of the tank neck (this allows for fuel expansion).

Replace fuel cap and tighten securely.

Clean up any spills before starting the engine.

OIL CAP /

DIPSTICK

Fig. 3

FUEL CAP

FUNNEL

Fig. 4

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionImportant Safety Instructions Read ALL Instructions Before Using this ProductSpecific Safety Rules Symbols Symbol Name DESIGNATION/EXPLANATIONSymbol Signal Meaning ServiceAuthorized Service Center for repair. When servic Features Product SpecificationsFeatures AssemblyRaising and Lowering the Telescoping Handle Handle TubeOIL CAP Dipstick Adding OIL to the EngineAdding Gasoline to the Fuel Tank Fuel CAPAssembling the Spray Wand Connecting High Pressure Hose to Spray Wand AssemblyTo attach the spray wand extension To connect the garden hose to the machine Connecting the High Pressure Hose to PumpConnecting the Garden Hose to Pressure Washer Water Intake Garden Hose ScreenApplications Primer Bulb Recoil Starter OFF SwitchOperation Starting and Stopping the Pressure WasherNozzle Using the Spray Wand TriggerSelecting the Right QUICK-CONNECT Nozzle for the JOB ClickWashing with Detergent Moving the Pressure WasherStoring the Pressure Washer Rinsing with the Pressure WasherCleaning the AIR Filter MaintenanceGeneral Maintenance AIR Filter CoverNozzle Cleaning Tool Removing the Wheel AssemblyNozzle Maintenance Checking a Fouled Spark PlugPreparing for USE After Storage Pump MaintenanceChanging the OIL Container OIL Drain PlugTroubleshooting Problem Cause SolutionPage Warranty Limited NON-ENGINE Warranty StatementService California Proposition
Top Page Image Contents