Husky HU80522 manual Raising and Lowering the Telescoping Handle, Handle Tube

Page 9

ASSEMBLY

WARNING:

If any parts are damaged or missing do not operate this

BUTTON

tool until the parts are replaced. Failure to heed this warn-

 

ing could result in serious personal injury.

 

WARNING:

Do not attempt to modify this tool or create accesso- ries not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.

HANDLE TUBE

WARNING:

To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.

NOTE: Do not start the pressure washer until the engine has been filled with oil, all hoses are connected, and the water is turned on. Running this machine without oil will damage the engine; running this machine without water will damage the high pressure pump.

RAISING AND LOWERING THE TELESCOPING

HANDLE

See Figure 2.

NEVER lift, or attempt to lift, the pressure washer by the telescoping handle. Only lift this product using the carrying handles located on each side of the unit.

To raise the handle, push the button while pulling the handle up and out of the handle tube.

NOTE: The handle will “click” as it locks in place.

To lower the handle, push the button while pushing the handle down into the handle tube.

HANDLE

Fig. 2

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsRead ALL Instructions Before Using this Product Important Safety InstructionsSpecific Safety Rules Symbol Name DESIGNATION/EXPLANATION SymbolsService Symbol Signal MeaningAuthorized Service Center for repair. When servic Product Specifications FeaturesAssembly FeaturesHandle Tube Raising and Lowering the Telescoping HandleAdding Gasoline to the Fuel Tank Adding OIL to the EngineOIL CAP Dipstick Fuel CAPConnecting High Pressure Hose to Spray Wand Assembly Assembling the Spray WandTo attach the spray wand extension Connecting the Garden Hose to Pressure Washer Connecting the High Pressure Hose to PumpTo connect the garden hose to the machine Water Intake Garden Hose ScreenOperation Primer Bulb Recoil Starter OFF SwitchApplications Starting and Stopping the Pressure WasherSelecting the Right QUICK-CONNECT Nozzle for the JOB Using the Spray Wand TriggerNozzle ClickStoring the Pressure Washer Moving the Pressure WasherWashing with Detergent Rinsing with the Pressure WasherGeneral Maintenance MaintenanceCleaning the AIR Filter AIR Filter CoverNozzle Maintenance Removing the Wheel AssemblyNozzle Cleaning Tool Checking a Fouled Spark PlugChanging the OIL Pump MaintenancePreparing for USE After Storage Container OIL Drain PlugProblem Cause Solution TroubleshootingPage Limited NON-ENGINE Warranty Statement WarrantyCalifornia Proposition Service
Top Page Image Contents