ASSEMBLY
ASSEMBLING THE SPRAY WAND
See Figure 5.
To attach the spray wand extension:
Place the threaded end of the wand extension in the connector on the end of the spray wand assembly.
Turn the connector clockwise until it stops. This secures the wand extension in place.
When not in use, remove the spray wand extension from the spray wand by turning the connector counter clock- wise. Store both pieces on top of the pressure washer.
CONNECTING HIGH PRESSURE HOSE TO SPRAY WAND ASSEMBLY
See Figure 6.
Screw the collar on the high pressure hose into the spray wand’s inlet coupler by turning the hose collar clock- wise.
Pull on the hose to be certain it is properly secured.
SPRAY
WAND
GROOVED
GRIPPING
SURFACE
CONNECTOR
SPRAY
WAND
EXTENSION
Fig. 5
COLLAR
HIGH PRESSURE | INLET | |
COUPLER | ||
HOSE | ||
|
Fig. 6
11