Karcher G 4000 RH manual Assembly Instructions, Water Supply Cold Water Only, Step

!Avoid tipping the machine on its side.

SAVE THESE INSTRUCTIONS

WATER SUPPLY (Cold Water Only)

￿CAUTION

When connecting the water inlet to the water supply mains, local regula- tions of your water company must be observed. In some areas the unit must not be connected directly to the public drinking water supply. This is to ensure that there is no feedback of chemicals into the water supply. Di- rect connection via a receiver tank or backflow preventer, for example, is permitted.

Dirt in the feed water will damage the unit. To avoid this risk, we recom- mend fitting a water filter.

!Garden hose must be at least 5/8 inch in diameter.

!Flow rate of water supply must not fall below 4.0 GPM (gallons per minute).

!Flow rate can be determined by run- ning the water for one minute into an empty 5-gallon container.

!The water supply temperature must not exceed 104°F/40°C.

!Never use the pressure washer to draw in water contaminated with sol- vents, e.g. paint thinners, gasoline, oil, etc.

!Always prevent debris from being drawn into the unit by using a clean water source.

!Do not operate pressure washer without the water turned on.

ASSEMBLY INSTRUCTIONS

"STEP 1:

Prior to initial startup, cut off tip of oil reservior cap on the pump.

"STEP 2:

Prior to initial startup, put engine oil (provided in bottle) in engine before starting the engine.

For engine details see engine manual.

"STEP 3:

Attach the handle to the frame of the pressure washer. Align holes, insert bolts, and tighten with knobs.

"STEP 4:

Mount the gun/hose storage handle.

English 5