Diamond Audio Technology D3 Series specifications Mixed-ModeSatellite and Subwoofer System

Page 7

Mixed-Mode Satellite and Subwoofer System

D3 400.2

Low HIGH FULL

Set X-Over Mode to FULL.

NOTE Chart values based on 4 ohm speakers.

Fig.7 The amplifier can be configured for a mixed-mode operation. The table provides component values to create a 6dB per octave crossover at specified frequencies. Use components that have a +-5% tolerance and capacitors rated at 100V. NOTE Choose the same frequency for both LP and HP crossovers. Do not overlap frequencies, as this may damage the amplifier.

Image 7

Contents INTRODUCTION TABLE OF CONTENTSDESCRIPTION POWER AND SPEAKER CONNECTIONS SPECIFICATIONSFig.3 D3 INPUT CONNECTIONS AND AUDIO CONTROLTROUBLESHOOTING SETTING THE GAINSETTING THE CROSSOVER SETTING THE BASS BOOSTBridged-MonoSubwoofer System SYSTEM DIAGRAMSSpecifications Set X-OverMode to FULL ADJUST FREQ to speakerSpecifications Set X-OverMode to LOW ADJUST FREQ to speakerMixed-ModeSatellite and Subwoofer System NOTE Chart values based on 4 ohm speakersSet X-OverMode to FULL Fig.8 Electrical connections for the D3 LOW HIGH FULL full-rangespeakers in stereoSOURCE 2CH BASS 2CH 4CH LOW HIGH FULL2CH BASS 2CH 4CH 4-ChannelStereo System2-Channel High-Pass. 2-Channel Low-Pass SOURCELOW HIGH FULL 2-ChannelStereo System with Low-passBridged Mono Channel SOURCE 2CH BASS 2CH 4CHSOURCE 2CH BASS 2CH 4CH SOURCE 2CH BASS 2CH 4CHLOW HIGH FULL LOW HIGH FULLMixed-ModeSystem On Rear Full-Range NOTE Chart values based on 4 ohm speakersSpeakers On Front Fig.14 Electrcal connections for the D3 LIMITED WARRANTY STATEMENT D I A M O N DListen as the Artist Intended Head Office 410 5. Benson Lane Chandler, AZ TelDate of Purchase A U D I O T E C H N O L O G Yw ww . di amo nd au di o .c om Serial Number