Diamond Audio Technology D3 Series Mixed-ModeSystem On Rear Full-Range, Speakers On Front

Page 13

Mixed-Mode System On Rear Full-Range

Speakers On Front

SOURCE

2CH BASS 2CH 4CH

D3 400.4

LOW HIGH FULL

NOTE Chart values based on 4 ohm speakers.

Fig.13 The amplifier can be configured for a mixed-mode operation on either channels 1/2 or 3/4 amplifier sections. The table provides component values to create a 6dB per octave crossover at specified frequencies. Use the same frequency for both LP and HP crossovers. Do not overlap frequencies, as this may damage the amplifier.

Image 13

Contents INTRODUCTION TABLE OF CONTENTSDESCRIPTION POWER AND SPEAKER CONNECTIONS SPECIFICATIONSFig.3 D3 INPUT CONNECTIONS AND AUDIO CONTROLSETTING THE CROSSOVER SETTING THE GAINSETTING THE BASS BOOST TROUBLESHOOTINGBridged-MonoSubwoofer System SYSTEM DIAGRAMSSpecifications Set X-OverMode to FULL ADJUST FREQ to speakerSet X-OverMode to LOW ADJUST FREQ to speaker SpecificationsMixed-ModeSatellite and Subwoofer System NOTE Chart values based on 4 ohm speakersSet X-OverMode to FULL Fig.8 Electrical connections for the D3 SOURCE 2CH BASS 2CH 4CH full-rangespeakers in stereoLOW HIGH FULL LOW HIGH FULL2-Channel High-Pass. 2-Channel Low-Pass 4-ChannelStereo SystemSOURCE 2CH BASS 2CH 4CHBridged Mono Channel 2-ChannelStereo System with Low-passSOURCE 2CH BASS 2CH 4CH LOW HIGH FULLLOW HIGH FULL SOURCE 2CH BASS 2CH 4CHLOW HIGH FULL SOURCE 2CH BASS 2CH 4CHMixed-ModeSystem On Rear Full-Range NOTE Chart values based on 4 ohm speakersSpeakers On Front Fig.14 Electrcal connections for the D3 Listen as the Artist Intended D I A M O N DHead Office 410 5. Benson Lane Chandler, AZ Tel LIMITED WARRANTY STATEMENTw ww . di amo nd au di o .c om A U D I O T E C H N O L O G YSerial Number Date of Purchase