Diamond Audio Technology D3 Series Set X-OverMode to FULL, Specifications, Low HIGH FULL

Page 6

2-Channel Full-Range, Satellite, of Subwoofer Stereo System

D3 400.2

Set X-Over Mode to FULL

Low HIGH FULL

Set X-Over Mode to FULL

ADJUST FREQ to speaker

Specifications

Low HIGH FULL

Set X-Over Mode to LOW

ADJUST FREQ to speaker

Specifications

Low HIGH FULL

Fig.6 In this application, the amplifier is used in stereo and drives two full-range (or satellite or subwoofer) speakers. NOTE A passive crossover must be used with satellite speakers.

Image 6

Contents TABLE OF CONTENTS INTRODUCTIONDESCRIPTION SPECIFICATIONS POWER AND SPEAKER CONNECTIONSINPUT CONNECTIONS AND AUDIO CONTROL Fig.3 D3SETTING THE BASS BOOST SETTING THE GAINSETTING THE CROSSOVER TROUBLESHOOTINGSYSTEM DIAGRAMS Bridged-MonoSubwoofer SystemSet X-OverMode to LOW ADJUST FREQ to speaker Set X-OverMode to FULL ADJUST FREQ to speakerSpecifications SpecificationsNOTE Chart values based on 4 ohm speakers Mixed-ModeSatellite and Subwoofer SystemSet X-OverMode to FULL Fig.8 Electrical connections for the D3 LOW HIGH FULL full-rangespeakers in stereoSOURCE 2CH BASS 2CH 4CH LOW HIGH FULLSOURCE 4-ChannelStereo System2-Channel High-Pass. 2-Channel Low-Pass 2CH BASS 2CH 4CHSOURCE 2CH BASS 2CH 4CH 2-ChannelStereo System with Low-passBridged Mono Channel LOW HIGH FULLLOW HIGH FULL SOURCE 2CH BASS 2CH 4CHLOW HIGH FULL SOURCE 2CH BASS 2CH 4CHNOTE Chart values based on 4 ohm speakers Mixed-ModeSystem On Rear Full-RangeSpeakers On Front Fig.14 Electrcal connections for the D3 Head Office 410 5. Benson Lane Chandler, AZ Tel D I A M O N DListen as the Artist Intended LIMITED WARRANTY STATEMENTSerial Number A U D I O T E C H N O L O G Yw ww . di amo nd au di o .c om Date of Purchase