Cub Cadet 2200H manual Troubleshooting

TROUBLESHOOTING - continued

Symptom	Cause	Solution
No detergent.	Detergent suction tube not	Check connection.
	properly connected to the
	machine.
	Detergent is too thick.	Dilute detergent, for best results
		use Cub Cadet detergent.
	The filter is closed.	Open the filter by turning it to the
		desired detergent intake.
	Filter on detergent suction	Run warm water through filter to
	tube is clogged.	remove debris.
	Damaged or clogged	Remove obstruction or replace
	detergent suction tube.	detergent suction tube.
	Spray wand is in high	Turn spray wand tip to low pressure
	pressure position.	position.
	Discharge nozzle is	Blow out or remove debris with a
	obstructed.	fine needle.
Garden hose	Loose fittings.	Tighten fittings.
connection leaks.
	Missing/worn rubber	Insert new washer.
	washer.
Spray wand or Spray	Spray wand not properly	Insert the spray wand into the spray
extension wand	attached.	wand extension. Carefully press in
leaks.		against the spring tension and twist
		into the locked position.
	Spray wand extension not	Slide the spray wand extension into
	properly attached.	the gun. Turn the wand collar
		clockwise onto the gun threads until
		tight.
	Broken o-ring or plastic	Contact your local Cub Cadet
	insert.	dealer.
Pump is noisy.	Pump is sucking air.	Check that hoses and fittings are air
		tight. Turn off machine and purge
		pump by squeezing trigger gun until
		a steady flow of water emerges
		through the nozzle.
Water leaks from	Loose fittings.	Check that all fittings are tight.
pump (up to 10 drops
	Thermal protection device	Thermal protection device will
per minute is
	has been activated.	automatically reset.
permissible).
	Water seals are damaged	Contact your local Cub Cadet
	or worn.	dealer.
Oil Drip.	Oil seals are damaged or	Contact your local Cub Cadet
	worn.	dealer.

•If you encounter any additional difficulties not listed, please contact your local Cub Cadet dealer.

13