CARTON CONTENTS
The following parts are shipped loose with your pressure washer:
=' Main
oHigh Pressure Hose
•Parts Box #1 (which includes items listed below)
•Rotating Brush
•Vehicle/Boat Wash
®
®Parts Box #2(which includes items listed below)
oAdjustable Nozzle ,, Turbo Nozzle
,,Spray Gun
,,Nozzle Extension
°Wire Form Motor Oil
°Manual Bag (which includesthe items listed below)
=Owner'sManual
,Nozzle Cleaning Kit
•
Become fam']iiarwith each piece before assembling the pressure washer. Check all contents against the illustra- tion on Page 6. if any parts are missing or damaged, call the Pressure Washer Helpline at
TO REMOVE PRESSURE WASHER FROM CARTON
Remove parts boxes included with pressure washer.
The high pressure hose is Packed in the bottom of the carton. Remove the hose.
=Slice two corners at handle end of carton from top to bottom so the panel can be folded down flat.
°Raise handle, secure in place with the locking caps and roll the pressure washer out the open end of the carton.
Locking Caps
How TO SET UP YOUR PRESSURE WASHER
For the most part, your Craftsman High Pressure Washer has been assembled at the factory. You must, however, attach the wire form, assemble the spray gun, and attach the high pressure hose to the pump and spray gun.
,,While facing the rear of the Pressure Washer, insert
the wire support with the longer arm positionedon the left. From this view the hook should resemble a "J".
/
oCut tie wrap on chemicalinjection tube. Remove chemi- cal injection filter, thread chemical injec_ontube through the wire form and reinsert filter into tube.
°Check carton for additional loose parts.