RINSING WiTH THE PRESSURE WASHER
WARNING Be extremely careful if you must use the pressure washer from ladder, scaf- folding or any other relatively unstable loca- tion. Pressure in a running washer builds in the wand as you climb. When you press the trigger, the recoil from the initial spray could force you to fail, or if you are too close to the cleaning surface, high pressure could force you off a climbing apparatus.
•Hook up the water supply and start your pressure washer (see TO START THE PRESSURE WASHER).
•Slide adjustable nozzle back to high pressure position and wait for detergent to clear. Detergent will not flow
when in the high pressure mode.
=When detergent has cleared you may want to expand
the spray pattern for a more gentle rinsing action. Start at top of area to be rinsed, working down with same action as for cleaning.
You can also stop detergent from flowing by simply removing_phon from bottle.
HOW TO USE ADJUST PRESSURE USING
THE PRESSURE CONTROL KNOB
Located on the pump is a pressure controlknob. You can increase and decrease the pressure of the spray by turn- ing the knob clockwise or counterclockwiserespectively.
_,The knob is set at maximum pressure at the factory.
HOW TO USE THE TURBO NOZZLE.
The turbo nozzle rotates the high pressure stream in a rapid circular pattern. This increases the cleaning effec-
tiveness of the high pressure spray, Attach the turbo noz- zle on the end of the nozzle extension.
The high pressure spray is most effective when the tip of the wand is held between 8 to 24 inches from the surface
being cleaned.
Important: The turbo nozzle produces an extremely high pressure spray which is capable of removing paint and cuffing holes through surfaces if held too close. Always make sure the surface you will clean will not be damaged by the high pressure spray.
HOW TO USE THE ROTATING BRUSH
Your pressure washer comes equipped with a rotating brush. Use the brush to clean especially dirty surfaces, it is a soft bristle brush with feathered ends that will not scratch surfaces.
To connect the rotating brush to the spray gun:
oAttach the accessory adapter to the rotating brush.
oAfter attaching the accessories adapter onto the rotat-
ing brush, attach the accessory adapter to the nozzle extension.
- After attaching the accessories adapter onto the noz- zle extension, attach nozzle extension onto spay gun.
Note: The rotating brush operates in low pressure setting allowing you to dispense chemical with the brush.