IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as the carburetor, fuel filter hose or tank during storage. Also, experience indicates that
Occur.
NOTE: Never start pressure washer without water source turned on and connected to pressure washer.
To Start Your Pressure Washer
Make sure fuel shutoff valve is turned to the open position. Turn
•Remove gas cap.
•Add unleaded gasoline, slowly, to fuel tank.
•Do not overfill.
•Connect garden hose to the water inlet on the
pressure washer. Tigthen by turning water inlet counterclockwise.
•Connect high pressure hose to discharge on pump.
•Connect the garden hose to the water spout
and turn water supply on.
•Squeeze trigger on pressure washer wand to relieve air pressure caused by turning on the water. Water will spew out of the gun in a thin stream. This will make it easier to start the engine.
•Engage the safety latch on the spray gun. This locks the trigger in place and keeps you from accidentally spraying a high pressure stream.
SAFETY
I_ATCH
•On the engine there is a choke/run lever. Place lever to the choke position.
•On the engine there is a throttle control lever. Place
throttle to the rabbit position. Always start engine with throttle in the rabbit position,
•Grasp the starter grip and pull slowly until resistance is felt, then pull firmly to start engine.
•Grasp the starter grip and pull slowly until resistance is felt, then pull firmly to start engine.
•When engine starts, gradually move choke lever to RUN position.
•If engine does not start after 5 pulls, place choke back to run postion,
•For hot engine starts make sure choke lever is in the run positon. Make sure fuel shut off valve is open and throttle is in the rabbit position.
NOTE." If any leaks are present shut unit down and tighten fittings,
10