Craftsman 580.768020 manual Engine Maintenance, Changing Oil, Carburetor

Page 12

ENGINE MAINTENANCE

Maintenance, replacement or repair of the emission control devices and svstems may be

performed by any non-road engine repair establishment or individual.

Checldng Oil Level

Oil level should be checked prior to each use or at least every 5 hours of operation. Keep oil level maintained,

Changing Oil

Change engine oil after the first 2 hours and every 50 hours thereafter. If you are using your cleaning system under extremely dirty or dusty conditions, or in extremely hot weather, change oil more often. ,

-Changeoil while engine is still warm from running, as follows:

Drain fuel tank by running pressure washer until

fuel tank is empty.

.,

Clean area around oil fill, remove oil fill cap/dipstick. Wipe dipstick clean.

Tip your pressure washer to drain oil frbm.the.oil fill tube into a suitable-container. Whdh c_n-k_case is

empty, return the pressure washer to upright position.

Fill engine crankcase with recommended oil until oil

level is at FULL point on dipstick. Do not overfill above that mark. POUR SLOWLY.

When engine crankcase is filled to proper level, install end tighten oil cap/dipstick.

To clean or replace the air cleaner, follow these steps:

Remove screw on the air cleaner cover.

Remove dirty air cleaner carefully to prevent debds from falling into carburetor. Discard.

Clean inside of tilter case.

Install new air filter.

Reassemble all parts and fasten securely to the carburetor with the screw.

Clean / Replace Spark Plug

Clean or replace the spark plug yearly or every 100 hours of operation.

,_ CAUTION:spark plug andDisconnectkeepwiresparkawayplugfromwiresparkfrom plug.

Clean area around spark plug.

Remove and inspect spark plug.

Replace spark plug if the electrodes are pitted, burned or porcelain is cracked. For replacement use Champion RJ-19LM or equivalent.

Check electrode gap with wire feeler gauge and set gap at-.030 inches, if necessary.

\

Service Air Cleaner

Your engine will not run properly and may be damaged if you run it with a dirty air cleaner.

Replace the air cleaner once every 100 hours of operation or once each year, whichever comes first.

Replace more often if operating under dirty or dusty conditions. Do not attempt to clean or oil filter. Replacements are available at your local Sears

Authorized Service Center.

install spark plug, tighten securely.

Carburetor

If you think your carburetor needs adjusting, see your nearest Sears Service Center. Engine performance may be affected at altitudes above 4000 feet. For operation at higher elevations, contact your nearest Sears Service Center.

12

Image 12
Contents Icraftsmani Limited ONE Year WARRANt on Craftsman High Pressure Washer Sears, Roebuck and Co., Dept WA, Hoffman Estates, ILSystem Carton Contents To Remove Pressure Washer from CartonKnow Your High Pressure Washer Gas Cap Throttle ControlHOW to USE Your Cleaning System How To Use Ute Adjustable NozzleCleaning With The Adjustable Nozzle Before Starting the Cleaning System Wash and Rinse SurfaceAdd Engine Oil Add GasolineHOW to Stop Your Pressure Washer To Start Your Pressure WasherSiphoning TipsMaintenance Task Hourly Operating Interval Service DatesWater Supply Temperature Rated Horsepower SparkNozzle Maintenance Pressure Washer MaintenanceCheck Chemical Reservoirs Check Gun and.WandRings, yellow, p/n B2264 for the ends Engine Maintenance Changing OilCarburetor Winter Storage Long Term StorageProtect Fuel System Problem Cause Correcon Runs roughPage Label KIT-EMISSION Carburetor KITValveoverhaul Gasketset Craftsman 2000 PSi Cleaning System Briggs Stratton 6HP Quantum #12H802-2383-E1Itern Kit Pa# Craftsman 2000 PSI Cleaning System Pump Craftsman 2000 PSI Cleaning System 580.768020 Pump Craftsman 2000 PSI Cleaning System 580.768020 Main Unit Craftsman 2000 PSI Cleaning System Main Unit Warranty Coverage Owners Warranty ResponsibilitiesFuel Pump Air Induction System MY-HOME