HOW to USE Your Cleaning System

Read these instructions and learn how to use your cleaning system before you attempt to start your cleaning system. If you have any problems operating your cleaning system, please call the pressure washer helpline at 1-800-222-3136.

How To Use Ute Adjustable Nozzle

AARNING! Never adjust spray pattern when

spraying. Never put hands in front of the nozzle when adjusting the spray.

•Push the nozzle forward for low pressure. Pull the nozzle backward until it "snaps" into plac'e'to achieve high pressure.

Pull nozzle	Push nozzle forward
backward for high	for low pressure.
pressure.

•Twisting the nozzle adjusts the spray pattern from a narrow to a "fan" pattern.

Twist nozzle	Twist	nozzle
clockwise for	counterclockwise for
narrow spray.	"fan"	pattern.

For most effective cleaning, keep spray nozzle between 8 to 24 inches away from cleaning surface.

Damage to the surface may occur if you get the spray nozzle too close to it.

Cleaning With The Adjustable Nozzle

ASystem,AUTION:makeBeforesurestartingyouhaveyourreadCleaningandfollowed the instructionsin the sections "Before Starting the Cleaning System" on page 7 and =To Start the Cleaning System" on page 8.

IMPORTANT: Use soaps designed specifically for pressure washer cleaning systems. Household detergents could damage the pump.

IMPORTANT: You must attach all hoses before you

start the engine. Starting the engine without all the hoses connected and without the water turned ON will

damage the pump.

Up to three (3) different solutions can be carded on the cleaning system at one time. To apply detergent follow these steps:

•Dilution is necessary when using the supplied chemical packets. Simply snip one comer of the

plastic pouch, pour the chemical into the tank, then fill the tank with clean water. Label tanks with the

provided tank labels

Pour ohemlcal into one of the tanks labeled A, B, C.

If using another chemical designed for use with pressure washers, prepare the chemical solution as required by the chemical manufacturer. Fill chemical reservoir(s)with the prepared solution as needed.

•Rotate the DiaI-A-CleaneF M selector knob to the letter correspondingto the desired reservoir.

•Push the adjustable nozzle forward to low pressure mode. Detergent cannot be applied with nozzle in high pressure position.

•Review the use of the adjustable nozzle.

•Connect garden hose to water inlet, check that high pressure hose is connected to spray gun and pump (see ASSEMBLY on page 4), and start engine.