CHANGING NOZZLES ON SPRAY WAND
Risk of Flying Object could cause risk of serious injury. DO
NOT attempt to change nozzles while pressure washer is running. Turn engine off before changing nozzles.
1.Pull quick connect coupler back and insert nozzle.
2.Release quick connect coupler
and twist nozzle to make sure it is secure in coupler.
Risk of Flying Object could
cause risk of serious injury. Ensure nozzle is completely inserted in QC socket, and QC snap ring is fully engaged (forward) before squeezing gun trigger.
Risk of injection or injury to person.
Do not direct discharge stream toward persons, unprotected skin, eyes, or any pets or animals. Serious injury can occur.
HOW TO APPLY CHEMICALS AND CLEANING SOLVENTS
Applying chemicals or cleaning solvents is a low pressure operation. NOTE: Use only soaps and chemicals designed for pressure washer use. Do not use bleach.
To Apply chemicals: |
|
1. Press chemical | Barb |
hose onto | Fitting |
barbed fitting |
|
located near high |
|
pressure hose |
|
connection of |
|
| |
pump as shown. |
|
2.Place other end of chemical hose with filter on it into container holding chemical/cleaning solution. NOTE: For every 7 gallons of water pumped 1 gallon of chemical/cleaning solution will be used.
3.Install low pressure (black) nozzle into quick connect fitting of spray wand, see How To Use Spray Wand paragraph in this section.
4.After use of chemicals, place chemical hose into container of clean water and draw clean water through chemical injection system to rinse system thoroughly. If chemicals remain in the pump it could be damaged. Pumps damaged due to chemicals will not be covered under warranty.
NOTE: Chemicals and soaps will not siphon when spray wand is in the high pressure setting.
11- ENG | A09741 |