ASSEMBLY INSTRUCTIONS
1.To Assemble Quick Connect Grommets:
a.Squeeze grommet and place into hole, fitting groove to rim.
b.Push grommet into place.
c.Repeat steps until all grommets are assembled.
2.To Assemble Quick Connect Nozzles:
a.Remove four colored quick connect nozzles from plastic bag and insert them into correct grommet. NOTE: Nozzles are color coded to match colored nozzles on panel.
3.Place handle assembly onto frame, depress the snap buttons, and slide the handle assembly onto the frame until snap buttons snap into place.
4.Attach high pressure hose to gun. Tighten securely.
5.Connect wand to gun. Tighten securely.
6.Add engine oil (supplied) to engine. Refer to Engine Owners Manual supplied by engine manufacturer for correct procedure.
NOTE: There will be a slight amount of oil in the engine from factory testing.
NOTE: The high pressure pump was filled with oil at the factory. The oil in the high pressure pump was designed to last the life of the pump. If there is a problem with the pump contact an Authorized Service Center.
The shipping plug must be removed and replaced with the dipstick/oil
plug before operating pressure washer.
7.Using an 11/16" wrench, remove shipping plug from pump
by turning it
counterclockwise. Discard plug.
8.Remove dipstick/oil plug from plastic bag and install into pump, tighten securely.
7- ENG | A09741 |