Delta D2750H HOW to Clean the Water Inlet Filter, HOW to Remove the Wheels, Remove filter by

Page 14

HOW TO CLEAN THE WATER INLET FILTER

This screen filter should be checked periodically and cleaned if necessary.

1.

Remove filter by

Filter Screen

 

grasping end and

 

 

removing it from

 

 

water inlet of pump

 

 

as shown.

 

2.

Clean filter by flushing it with

 

water on both sides.

 

3.

Re-insert filter into water inlet

 

of pump. NOTE: Cone side faces

 

out.

 

NOTE: Do not operate pressure washer without filter properly installed.

HOW TO REMOVE THE WHEELS

1.Using a 1/8" hex head wrench loosen set screw in hub collar.

2.Slide hub collar from axle and remove the tire.

A09741

14- ENG

Image 14
Contents For Parts, Service, Warranty or other Assistance Please call To learn more about Delta MachineryImportant Safety Instructions Safety Guidelines DefinitionsConsumer Safety Information Risk of Explosion or FireRisk to Fluid Injection Risk of Explosion or FireRisk to Breathing Risk of Chemical Burn Risk of Electrical ShockRisk of Unsafe Operation Risk of Injury from SprayCarton Contents To Assemble Quick Connect Nozzles Assembly InstructionsTo Assemble Quick Connect Grommets Choke Control Opens and closes carburetor choke valve Engine Switch Enables and disables ignition systemBasic Elements of a Pressure Washer Pressure Pressure AdjustmentsPressure Washer Terminology RegulatorNozzle Color Red Yellow White Black Read and Understand ALL Warnings Before Starting UnitTo USE Spray Wand UsesHose onto HOW to Apply Chemicals and Cleaning SolventsTo Apply chemicals Press chemical Starting Shutting DownEngine Pump MaintenanceNozzle Cleaning Remove filter by HOW to Clean the Water Inlet FilterHOW to Remove the Wheels Re-insert filter into water inletStorage Pressure WasherCausecorrection Trouble Shooting GuideProblem Problem Cause Correction Warranty