Poseidon 2
4.5Start and stop of the ma- chine (when connected to a water supply)
4.6Start the machine (when connected to open con- tainers (suction mode))
The spray lance is affected by a thrust during opera- tion - therefore always hold it
firmly with both hands. IMPOR- TANT: Point the nozzle at the ground.
1.Check that the machine is in upright position.
NOTE: Do not place the ma- chine in tall grass!
2.Release the trigger lock.
3.Activate the trigger of the spray handle and let the wa- ter run until all air has es- caped from the water hose.
4.Turn the start/stop switch (1) to position "I".
5.Activate the trigger of the spray handle.
Always adjust the distance and thus the pressure of the nozzle to the surface, which is to be cleaned.
The washer can take in water from a rain water tank as an example. The hose for the water supply must not be too long, approx. 5 m.
Make sure that the water tank is not placed on a lower level than the machine.
Use an external fi lter if the wa- ter contains impurities.
1.Make sure that the water hose is filled completely with water before connecting to the machine. Place the entire
Do not cover the machine during operation.
Note: If the ma- chine is left or not used for 5 minutes, it must
be switched off on the start/stop switch "O" (1):
1.Turn the start/stop switch to position "O".
2.Disconnect the electrical plug from the socket.
3.Shut off the water supply and activate the trigger to relieve the machine of pressure.
4.Lock the spray handle.
When releasing the trigger of the spray handle, the machine automatically stops. The ma- chine will start again when you
hose in a tank or bucket. To avoid water spillage, crimp the water inlet hose down in the water and then connect the hose to the machine with the quick coupling and finally uncrimp the water inlet hose.
2.Dismount spray handle, lance and nozzle.
3.Turn the start/stop switch to position "I" and let the water run, until the air has escaped from the water hose and the pump.
4.Mount spray handle, lance and nozzle again.
4.7Pressure regulation on the Flexopower Plus- spray lance
High pressure
Low pressure
The pressure can be regulated on the Flexopower Plus spray lance.
68 | Original Instructions |