Black & Decker PW1600 General Cleaning Tips, Maintenance, Accessories Service Information

GENERAL CLEANING TIPS

•Remove the fan wand (D) from the gun wand (F) as shown in Figure 28.

28

•Clean the nozzle with the cleaning tool (O). Remove any dirt from the fan wand nozzle hole as shown in Figure 29 and rinse.

29

•For cleaning tasks such as deck or brick patio cleaning, limit your work area to approximately 25 square feet at a time.

•Pre-rinse cleaning area with fresh water.

•Use only detergents formulated for pressure washers.

•Always test detergent in an inconspicuous area before use.

•Begin with a wide fan nozzle spray and adjust the pressure to the desired spray pattern.

•The best angle for spraying water against a cleaning surface is 45 degrees. Spraying head on tends to cause dirt particles to imbed in the surface. When working on vertical surfaces, it is best to apply detergent starting at the bottom and working upwards which will prevent the detergent from sliding down and causing streaks.

4.Disconnect the garden hose from the water inlet.

5.Without garden hose connected to unit, turn unit on for a few seconds and squeeze gun trigger until water spray stops. Turn off switch immediately.

6.Remove any remaining fluid from detergent tank.

7.Wrap power cord on rear of unit, clipping plug onto cord as shown in Figure 30.

30

8.Disconnect the high pressure hose from the high pressure outlet and drain hose by pressing gun trigger.

9.Engage the gun safety catch.

10.Wrap high pressure hose on front of unit as shown in Fig. 31.

31

MAINTENANCE

Clean the nozzle with the tool provided. Remove any dirt from the spray wand nozzle hole as shown in Figure 29 and rinse.

Use only mild soap and damp cloth to clean the tool. CAUTION: Never use the pressure washer to clean itself.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service personnel, always using identical replacement parts.

ACCESSORIES

WARNING: The use of any accessory not recommended for use with this pressure washer could be hazardous.

SERVICE INFORMATION

Do not return this product to your retailer. Black & Decker offers a full network of company-owned and authorized service locations throughout North America. All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service.

Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker location nearest you.

To find your local service location, refer to the yellow page directory under “Tools— Electric” or call: 1-800-544-6986.

This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other rights which vary from state to state and province to province. Should you have any questions, contact the manager of your nearest Black & Decker Service Center. This product is not intended for commercial use.

Free Warning Label Replacement: If your warning labels become illegible or are missing, call 1-800-544-6986 for a free replacement.

TECHNICAL INFORMATION

Operating pressure – 1250/1300psi Maximum pressure* - 1600/1700psi

1.Maximum Water Flow rate* - 1.6gpm

2.Electrical requirements – 120V, 15amps, 60hz

3.Electrical cord – 35ft

4.High pressure hose – 25ft

5.Minimum amperage source – 15amps

6.Pressure of inlet water –

20 to 80 psi

7.Inlet water – Cold water only

8.Chemical injection rate 0.1 gpm

*Water flow and Max. pressure ratings determined in accordance with PWMA standard PW101.

SHUTDOWN / STORAGE

1.Ensure detergent tank and dispensing system has been thoroughly rinsed as described on page 9, and empty tank has been replaced in unit. To empty remaining water from detergent system put on-off switch in “on” (I) position, and with nozzle in outward detergent pick up position, press gun trigger for 30 seconds. Water from the pump will still be sprayed at low pressure after 30 seconds, but detergent system will be purged.

2.Put the on-off switch in “off” (O) position and unplug the cord from the outlet.

3.Turn off water at the faucet.

10

O

I

IMPORTANT: Store pressure washer indoors away from areas that might freeze to avoid seriously damaging the pump.

TWO-YEAR HOME USE WARRANTY

Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material or workmanship. The defective product will be replaced or repaired at no charge. Do not return this product to your retailer.

Take or send the product (prepaid) to a Black & Decker owned or authorized Service Center for repair or replacement at our option. Proof of purchase may be required. Black & Decker owned and authorized Service Centers are listed under “Tools-Electric” in the yellow pages of the phone directory.

11

Black & Decker (U.S.) Inc.,

701 E. Joppa Rd.

Towson, MD 21286 U.S.A.

See ‘Tools-Electric’

– Yellow Pages –

for Service & Sales