OPERATION
APPLICATIONS
You may use this tool for the purposes listed below:
�Removing dirt and mold from decks, cement patios, and house siding
�Cleaning cars, boats, motorcycles, outdoor furniture, and grills
STARTING AND STOPPING THE PRESSURE WASHER
See Figures 11 - 12.
CAUTION:
Do not run the pump without the water supply connected and turned on.
Before starting the engine:
Connect all hoses.
Check all fluids (oil and gas).
Turn the garden hose on then squeeze the trigger to relieve air pressure; hold the trigger until a steady stream of water appears.
To start the engine:
Push primer bulb 3 times.
NOTE: If starting the engine for the first time, push the primer bulb 5 times.
Grasp the recoil starter and pull slowly until resistance is felt. Give the recoil starter a short, brisk pull to start the engine.
To stop the engine:
On the top of the engine is an OFF ( O ) switch. Press and hold the switch in the OFF position for three (3) seconds or until the engine stops.
PRIMER BULB 3X
RECOIL
STARTER
Fig. 11
OFF SWITCH
Fig. 12
13