ASSEMBLY
ATTACHING INJECTION HOSE
See Figure 6.
Before detergent can be used with this machine, the injection hose must be attached.
Push the open end of the clear injection hose securely over the fitting as shown in figure 6.
Place the filtered end of the injection hose in the bottle of detergent.
ASSEMBLING THE SPRAY WAND
See Figure 7.
To attach the spray wand extension:
Place the threaded end of the wand extension in the con- nector on the end of the spray wand assembly.
Turn the connector clockwise until it stops. This secures the wand extension in place.
When not in use, remove the spray wand extension from the spray wand by turning the connector counter clock- wise. When not in use, store both pieces on top of the pressure washer.
CONNECTING HIGH PRESSURE HOSE TO SPRAY WAND ASSEMBLY
See Figure 8.
Screw the collar on the high pressure hose into the spray wand’s inlet coupler by turning the hose collar clock- wise.
Pull on the hose to be certain it is properly secured.
INJECTION
HOSE
FITTING
Fig. 6
SPRAY
WAND
CONNECTOR
GROOVED
GRIPPING
SURFACE
SPRAY
WAND
EXTENSION
Fig. 7
COLLAR
HIGH PRESSURE | INLET | |
COUPLER | ||
HOSE | ||
|
Fig. 8
11