Briggs & Stratton 2700PSI Cleaning and Applying Chemical, To apply detergent follow these steps

Page 10

Snapper 2700 PSI Pressure Washer

Cleaning and Applying Chemical

After you have applied detergent, scour the surface and rinse it clean as follows:

CAUTION! You must attach all hoses before you start the engine. Starting the engine without all the hoses connected and without the water turned ON will damage the pump.

IMPORTANT: Use soaps designed specifically for pressure washers. Household detergents could damage

the pump.

To apply detergent follow these steps:

•Review the use of the nozzles.

•Prepare the detergent solution as required by the manufacturer.

•Place the chemical injection siphon/filter into the detergent container.

CAUTION! Keep the chemical injection tube from coming in contact with the hot muffler.

• Make sure the black nozzle is installed.

NOTE: Detergent cannot be applied with the high pressure nozzles (White, Green, Yellow, or Red).

•Make sure the garden hose is connected to the water inlet. Check that the high pressure hose is connected to the spray gun and the pump and start the engine.

•Apply the detergent to a dry surface, starting at lower portion of area to be washed and work upward, using long, even, overlapping strokes. Do Not allow the detergent to dry on (prevents streaking).

•Allow the detergent to soak in between 3–5 minutes before washing and rinsing. Reapply as needed to prevent surface from drying.

•Apply safety latch to spray gun.

•Remove the black chemical nozzle from the nozzle extension.

•Select and install the desired high pressure nozzle following the instructions “How to Use the Nozzles” on page 9.

•Keep the spray gun a safe distance from the area you plan to spray.

•Increase or decrease spray pressure by turning the pressure control knob counterclockwise or clockwise respectively (Figure 14). Use lower pressure to wash items such a as a car or boat. Use higher pressure to strip paint and degrease driveways.

Figure 14 — Pressure Control Knob

Pressure

Control

Knob

•Apply a high pressure spray to a small area and then check the surface for damage. If no damage is found, you can assume it is okay to continue cleaning.

•Start at the top of the area to be rinsed, working down with same overlapping strokes as you used for cleaning.

Pressure Washer Rinsing

WARNING! Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location. Hose water pressure builds as you climb. When you press the trigger, the recoil from the initial spray can be very strong. The high pressure spray could cause you to fall if you are too close to the cleaning surface.

Automatic Cool Down System

(Thermal Relief)

If you run the engine on your pressure washer for

3-5 minutes without pressing the trigger on the spray gun, circulating water in the pump can reach a temperature between 140–145°F. At this temperature, the system engages and cools the pump by discharging the warm water onto the ground. This system prevents internal damage to the pump.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Contact the Local Snapper Service Center 2700PSISafety Rules Table of ContentsEquipment Description High pressure spray may damage fragile items including glass Nozzle Extension with Quick Connect Allows you to Know Your Pressure WasherHigh Pressure Outlet with Quick Connect To Connect high pressure hoseWasher for USE Carton ContentsRemove Pressure Washer from Carton Attach Handle to the Pressure WasherTo install the oil dipstick Install Oil Dipstick on Pump Add GasolineAdd Engine Oil Checklist Before Starting Engine Connect Hose and Water Supply to PumpHOW to USE Your Pressure Washer How to Start Your EngineFollow these instructions to change nozzles How to Stop Your Pressure WasherHow to Use the Nozzles Low PressurePressure Washer Rinsing Automatic Cool Down System Cleaning and Applying ChemicalTo apply detergent follow these steps General Maintenance Recommendations SpecificationsPressure Washer Maintenance Check In-Line Filter Nozzle MaintenanceCheck Gun and Nozzle Extension Purge Pump of Air ContaminantsPreparing the Unit for Storage Storing the Engine Engine MaintenanceRing Maintenance To remove a worn or damaged o-ringSnapper 2700 PSI Pressure Washer Troubleshooting Exploded View Unit Parts List Unit Qty DescriptionExploded View Pump Parts List Pump Service KitsExploded View Unloader Parts List Unloader Snapper 2700 PSI Pressure Washer Snapper 2700 PSI Pressure Washer Snapper Owner Warranty Policy Effective October 1 Generac Portable Products, LLC Jefferson, Wisconsin U.S.A

2700PSI specifications

The Briggs & Stratton 2700PSI pressure washer is an outstanding choice for both residential and light commercial cleaning tasks. Known for its robust design and powerful performance, this pressure washer delivers a maximum pressure of 2700 PSI and a water flow rate of 2.3 GPM, making it capable of tackling a wide range of cleaning jobs, from driveways to decks and patios.

A key feature of the Briggs & Stratton 2700PSI is its reliable engine. Powered by a Briggs & Stratton OHV engine, this pressure washer provides enhanced durability and efficiency. The engine operates smoothly and is designed for easy starting, thanks to its patented Ready Start technology, which eliminates the need for a primer bulb. Users can expect hassle-free operation, reducing the frustration often associated with starting gas-powered equipment.

In terms of versatility, the 2700PSI model offers five interchangeable nozzles, allowing users to adjust the spray pattern according to the specific cleaning task at hand. Ranging from a focused, high-pressure stream to a wide, gentle spray, these nozzles ensure that users can clean delicate surfaces without causing damage while still achieving superior cleaning performance on tough stains.

One of the standout features of this pressure washer is its onboard detergent tank. This built-in tank allows for easy application of soap, making it ideal for breaking down grime and dirt on heavily soiled surfaces. The pressure washer also includes a soap nozzle, optimizing soap application for effective cleaning results.

The Briggs & Stratton 2700PSI is designed with user convenience in mind. It comes equipped with a 25-foot high-pressure hose, providing ample reach for various cleaning tasks without the need to constantly move the machine. Additionally, its compact and lightweight design, along with sturdy wheels, enhances portability, making it easy to transport and store when not in use.

Safety features are also integrated into the design of this pressure washer. The total stop system automatically shuts off the pump when the trigger is not engaged, prolonging the lifespan of the motor and pump while conserving energy.

Overall, the Briggs & Stratton 2700PSI pressure washer stands out as a powerful and efficient cleaning solution. With its reliable engine, versatile nozzles, onboard detergent tank, and thoughtful safety features, it represents a great investment for anyone looking to maintain their outdoor spaces with ease and effectiveness. Whether washing vehicles, cleaning siding, or prepping surfaces for painting, this pressure washer is equipped to handle the job efficiently, making it a popular choice among homeowners and professionals alike.
Top Page Image Contents