Briggs & Stratton 20262 Assembly, Preparing Pressure Washer for USE, Unpack the Pressure Washer

ASSEMBLY 3700 PSI Pressure Washer PowerBOSS™

ASSEMBLY

IMPORTANT: Read entire operator’s manual before you attempt to assemble or operate your new pressure washer.

Unpack the Pressure Washer

1.Remove everything from carton except pressure washer.

2.Open carton completely by cutting each corner from top to bottom.

3.Remove pressure washer from carton.

Carton Contents

Items in the carton include:

•Main unit

•High pressure hose

•Handle

•Engine oil

•Spray gun with quick connect fitting

•Nozzle extension with quick connect fitting

•Parts bag (includes the following):

•Owner’s registration card

•Safety goggles

•Bag containing 5 multi–colored quick connect spray tips

•Operator’s manual

•Engine operator’s manual

•Emissions control warranty sheet

•Handle Fastening Hardware Kit (which includes):

•Carriage Bolts (2)

•Plastic Knobs (2)

If any of the above parts are missing or damaged, call the pressure washer helpline at 1–800–743–4115.

PREPARING PRESSURE WASHER FOR USE

If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at 1-800-743-4115.

To prepare your pressure washer for operation, you will need to perform these tasks:

1.Fill out and send in registration card.

2.Verify oil dipstick has been installed into pump (Figure 1).

Figure 1 — Pump Dipstick

Pump Oil Dipstick

3.Attach handle to main unit.

4.Add oil to engine.

5.Add fuel to fuel tank.

6.Connect high pressure hose to spray gun and pump.

7.Connect water supply to pump.

8.Connect nozzle extension to spray gun.

9.Select/attach quick connect spray tip to nozzle extension.

7