ASSEMBLY | 3700 PSI Pressure Washer | PowerBOSS™ |
|
|
|
NOTE: Remove and discard all pump shipping caps before attaching hoses.
2.Similarly, attach other end of high pressure hose to high pressure outlet on pump (Figure 5). Pull down on collar of quick connect, slide onto pump and let go of collar. Pull on hose to be sure of tight connection.
Figure 5 — Connect High Pressure Hose to Pump
Connect high
pressure hose here
3.Before connecting garden hose to water inlet, inspect inlet screen (Figure 6).
Clean screen if it contains debris, replace if damaged.
DO NOT RUN PRESSURE WASHER IF SCREEN IS DAMAGED.
Figure 6 — Connect the Garden Hose to Water Inlet
Inspect inlet
screen, DO NOT
use if damaged,
clean if dirty.
4.Run water through garden hose for 30 seconds to clean out any debris.Turn off water.
IMPORTANT: DO NOT siphon standing water for the water supply. Use ONLY cold water (less than 100°F).
5.Connect garden hose (not to exceed 50 feet in length) to water inlet.Tighten by hand (Figure 6).
CAUTION
There MUST be at least ten feet of unrestricted garden hose between the pressure washer inlet and any flow shut off device, such as a ‘Y’
•Damage to equipment resulting from failure to follow this instruction will void warranty.
6.Turn ON water, point gun in a safe direction and squeeze trigger to purge pump system of air and impurities.
WARNING
High pressure spray can cause paint chips or other particles to become airborne.
•Always wear safety goggles when using this equipment or in vicinity of where equipment is in use.
•Before starting the pressure washer, be sure you are wearing adequate safety goggles.
Checklist Before Starting Engine
Review the unit’s assembly to confirm you have performed all of the following:
1.Make sure handle is in place and secure.
2.Check that oil has been added to proper level in engine crankcase.
3.Add proper fuel to fuel tank.
4.Check for properly attached hose connections.
5.Check to make sure there are no kinks, cuts, or damage to high pressure hose.
6.Provide a proper water supply (not to exceed 100°F) at an adequate flow.
7.Be sure to read “Safety Rules” and “How To Use Pressure Washer” before using pressure washer.
9