Briggs & Stratton 01936 owner manual Add Engine Oil, Add Fuel

Pressure Washer

To attach handle supplied with two “L” hooks (Model 01936):

1.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 7).

Figure 7 — Attach Handle to Base

Handle

Align Holes

Handle

Supports

NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.

2.Insert carriage bolts through holes from outside of the unit and attach a plastic knob from inside of unit (Figure 8).Tighten by hand.

Figure 8 — Secure Handle

3.Insert one “L” hook through hole just under billboard on left side of handle (viewing from rear of unit). Hold hook in place with pliers and attach locknut with 7/16” wrench (Figure 9).

Figure 9 — Attach “L” Hooks to Handle

Spray Gun

Hook

Hose Hook

Add Engine Oil

IMPORTANT: Any attempt to crank or start the engine before it has been properly serviced with the recommended oil may result in an engine failure.

•Place pressure washer on a level surface.

•Refer to engine owners manual to add recommended oil to engine.

NOTE: Check Oil Often During Engine Break–in.

Add Fuel

WARNING! NEVER fill fuel tank indoors. NEVER fill fuel tank when engine is running or hot.Allow unit to cool for two minutes before refueling. DO NOT light a cigarette or smoke when filling the fuel tank.

WARNING! DO NOT overfill the fuel tank. Always allow room for fuel expansion.

•Place pressure washer on a level surface.

•Refer to engine owners manual to add recommended fuel to engine.

4.Insert other “L” hook through hole just above billboard on right side of handle (viewing from rear of unit). Hold hook in place with pliers and attach locknut with 7/16” wrench (Figure 9).

7