Zenoah RMSZ2500 manual Fueling the Unit, For Your Engine LIFE, Avoid

Page 17

7. Fuel

again for at least one minute. As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary for the engine to last long. Be careful that, if the agitation is insufficient, there is an increased danger of early piston seizing due to abnormally lean mixture.

5.Put a clear indication on the outside of the container to avoid mixing up with gasoline or other containers.

6.Indicate the contents on outside of container for easy identification.

FUELING THE UNIT

1.Untwist and remove the fuel cap. Rest the cap on a dustless place.

2.Put fuel into the fuel tank to 80% of the full capacity.

3.Fasten the fuel cap securely and wipe up any fuel spillage around the unit.

WARNING

1.Select bare ground for fueling.

2.Move at least 10feet (3meters) away from the fueling point before starting the engine.

3.Stop the engine before refueling the unit. At that time, be sure to sufficiently agitate the mixed gasoline in the container.

FOR YOUR ENGINE LIFE, AVOID;

1.FUEL WITH NO OIL(RAW GASOLINE) – It will cause severe damage to the internal engine parts very quickly.

2.GASOHOL – It can cause deterioration of rubber and/or plastic parts and disruption of engine lubrication.

3.OIL FOR 4-CYCLE ENGINE USE – It can cause spark plug fouling, exhaust port blocking, or piston ring sticking.

4.Mixed fuels which have been left unused for a period of one month or more may clog the carburetor and result in the engine failing to operate properly.

5.In the case of storing the product for a long period of time, clean the fuel tank after rendering it empty. Next, activate the engine and empty the carburetor of the composite fuel.

6.In the case of scrapping the used mixed oil container, scrap it only at an authorized repository site.

NOTE

As lot details of quality assurance, read the description in the section Limited Warranty carefully. Moreover, normal wear and change in product with no functional influence are not covered by the warranty. Also, be careful that, if the usage in the instruction manual is not observed as to the mixed gasoline, etc. described therein, it may not be covered by the warranty.

17

Image 17
Contents RMS9-99102 RMSZ2500Page Contents Safety FirstParts location RMSZ2500 SpecificationsAvertissement Important Engine Information Symbols on the machineWorking Circumstance For safe operationWorking Condition Working Plan Starting the Engine Before Starting the EngineUse only for tasks explained in the manual Using the ProductHandling Fuel MaintenanceIf Someone Comes Transportation Set up Clevis Pin Hitch Pin Cotter Pin Drum Axle Drum Assembly SE4 Sweeper Assembly SE4Recommended Mixing Ratio Gasoline 50OIL HOW to MIX FuelFuel For Your Engine LIFE, Avoid Fueling the UnitOP1 OperationOP21 OP3 OP4 Starting EngineAdjusting Idling Speed OP6 Adjusting Throttle CableOP5 OP6 OP7 Stopping Engine OP3Direction of rotation OP8 OP9OP10 OP11 Operating and Safety Tips OP11Maintain a shallow angle to the work surface YOU Must Always Guard Against Thrown DebrisNever make unauthorized attachment installations Stay Alert General Safety InstructionsLoad Avoid low rpm operationGearcase Lubrication MaintenanceMaintenance Chart End cap Main gear MA1MA2 MA3 MA4 Replacement Plug is a NGK CMR7AAIR Filter Fuel FilterMuffler MA5Spark Arrester Spark ArresterMA61 Procedures to be Performed After Every 100 Hours of USEMA7 Cylinder Intake Air Cooling Vent backCheck Probable Causes Action Troubleshooting guideStorage Parts list RMSZ2500  31   32   33  Limited Warranty RedMax Garantie limitée Komatsu Zenoah America INC