Zenoah PSZ2401 manual Manufacturer’s warranty coverage, Owner’s warranty responsibilities

Page 60

CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT

YOUR WARRANTY RIGHTS AND OBLIGATIONS

The California Air Resources Board and ZENOAH AMERICA, INC. are pleased to explain the emission control system warranty on your 2007 and later small off-road engine. In California, new small off-road engines must be designed, built and equipped to meet the state’s stringent anti-smog standards. ZENOAH AMERICA, INC. must warrant the emission control system on your small off-road engine for the periods of time listed below provided there has been no abuse, neglect or improper maintenance of your small off-road engine.

Your emission control system may include parts such as the carburetor, fuel tank and the ignition system.

Where a warrantable condition exists, ZENOAH AMERICA, INC. will repair your small off-road engine at no cost to you including diagnosis, parts and labor.

Manufacturer’s warranty coverage:

The 2007 and later small off-road engines are warranted for two years. If any emission- related part on your engine is defective, the part will be repaired or replaced by ZENOAH AMERICA, INC.

Owner’s warranty responsibilities:

–As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. ZENOAH AMERICA, INC. recommends that you retain all receipts covering maintenance on your small off-road engine, but ZENOAH AMERICA, INC. can not deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

–As the small off-road engine owner, you should be aware, however, that ZENOAH AMERICA, INC. may deny you warranty coverage if your small off-road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modification.

–You are responsible for presenting your small off-road engine to a ZENOAH AMERICA, INC. distribution center as soon as a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact ZENOAH AMERICA, INC. at (770)-381-5147 or you can write to

ZENOAH AMERICA, INC.

1100 Laval Blvd. Suite 110

Lawrenceville, Georgia 30043

PSZ2401-CA only

Page 59 Page 61
Image 60
Page 59 Page 61
Contents PSZ2401 PSZ2401-CA Contents Differents Types D’AVERTISSEMENT DE CE Mode D’EMPLOI Tables des matieres ContenidoAdvertencias Contenidas EN EL Manual Specifications Parts locationPSZ2401/PSZ2401-CA Emplacement des pieces Situación de las piezas Fiche techniqueEspecificaciohes PSZ2401-CA/PSZ2401-CASymbols on the machine Importante For safe operation Working ConditionWorking Circumstance Conditions DE Travail Condiciones DE TrabajoPrecauciones Working Plan Before Starting the EnginePlan DE Travail Plan DE TrabajoLA Machine Avant DE Mettre LE Moteur EN MarcheStarting the Engine Demarrage DU Moteur Arranque DEL MotorUsing the Product MaintenanceIf Someone Comes Check okSI QUELQU’UN S’APPROCHE SI Alguien SE AproximaEntretien Mantenimiento Tout est en ordre de marcheHandling Fuel Refill after cooling the engineManipulation DU Carburant Manipulación DEL CombustibleLlenar una vez que el motor se haya enfriado Kickback and Pinching Safety Precautions Beware of kickbackTransportation Beware of pinchingPrecautions DE Securite Contre LE Rebond ET LE Pincement Precauciones DE Seguridad DERetroceso Y Pellizco Tenga cuidado con el retroceso Tenga cuidado con el pellizcoFor safe operation Importante Set up Raccordement Cable ’ACCELERATEUR Raccordement DES Fils ElectriquesFixation DU Mecanisme DE Debrouissaillage SE4 Conexión DEL Alambre DEL AceleradorChain tension adjusting screw Loosen Tighten SE5 SE6 SE7 SE8Pay attention to the correct direction of the saw chain Hole Moving direction Chain tensioner nutAssemblage Montaje Un paquet standard de cette tronçonneuse contient lesGaine de protection comme suit De engranaje como sigue Agujero Dirección de movimiento Tuerca de tensión de cadenaSE9 Balance UnitUnite DE Balance Unidad DE BalanceWhen using RedMax/ZENOAH genuine oil Fuel and Chain OilRecommended Mixing Ratio Gasoline 50OIL Rapport DE Melange Recommande Essence 50 Huile Lors de l’utilisation de la véritable huile RedMax/ZENOAHProporción DE LA Mezcla Recomendada Gasolina 50 Aceite Al utilizar el aceite auténtico de RedMax/ZENOAHHOW to MIX Fuel Fueling the UnitFor Your Engine LIFE, Avoid Comment Obtenir UN BON Melange Como Mezclar EL Combustible Remplissage DU ReservoirEviter Pour Prolonger LA Duree DE VIE DU Moteur Abastecimiento DE LA UnidadChain OIL Huile Pour Chaîne Aceite Para LA CadenaOperation OP1 OP2 OP3OP5 Starting Engine Combustible Huile pour chainette Combustible Aceite para cadenaLevier du starter Fermé Cerrar Ouvert AbrirAdjusting OIL Flow Rate OP6Stopping Engine OP4 Checking OIL SupplyArret DU Moteur OP4 Cómo Parar EL Motor OP4 Contrôle DU Graissage DE LA ChaîneReglage DU Debit D’HUILE Control DEL Suministro DE AceiteAdjust the pump as follows Adjusting Throttle CableCable adjuster OP7 OP8Reglage Câble D’ACCÉLÉRATEUR Ajuste Cable DEL AceleradorOP9 Adjusting Idling Speed OP9 Idle adjusting screwReglage DU Ralenti OP9 Vis de réglage du ralentiAjuste DE LA Velocidad DE Marcha EN Vacío OP9 Tornillo de ajuste de marcha mínimaMaintenance Maintenance ChartMantenimiento Tableau D’ENTRETIENTabla DE Mantenimiento MA1 MA2 MA3 MA4 MA5 Oiling PortGuide BAR OthersBarre Guide Barra DE Guía Divers OtrosPignon Rueda DentadaMA6 MA7 MA8 SAW ChainChain type 90SG File size 32 in 4.0mm Méihode et critères daffûtage Porter des gants de sécurité Avant laffûtageType de chaîne 90SG Taille de la lime 5/32 de pouce 4.0mm Normas para el ajuste de los dientesReplacement Plug is a Champion RZ7C MA9AIR Filter Fuel FilterEntretien Mantenimiento Muffler Spark Arrester MA12Gear Case MA13 Grease fittingPARE-ETINCELLES MA12 Gaine Protectrice MA13Ouïe DU Refroidissement PAR AIR Parachispas MA12Procedures to be Performed After Every 100 Hours of USE StorageDisposal Cylinder Intake air cooling vent backProcedure a Effectuer Toutes LES 100 Heures D’UTILISATION Mortes et autres débris avant d’utiliser la machineCilindro Toma de aire de refrigeración posterior Procedimientos a Realizar Cada Horas DE USOTroubleshooting guide 13. Guía de localización y solución de problemasGuide de localisation des pannes PSZ2401 PSZ2401-CA NotaParts list Pipe Comp Engine Unit PSZ2401/PSZ2401-CA S/N 60600101 and up Cylinder Comp Manufacturer’s warranty coverage Owner’s warranty responsibilitiesCouverture de la garantie constructeur Obligations du propriétaire liées à la garantieCobertura de la garantía dada por el fabricante Responsabilidades del propietarioLimited Warranty Garantie limitée Garantía Limitada Page Page Emission Control Mesures DE Lutte Contre Control DE Emisiones LES EmissionsPSZ2401 PSZ2401-CA

PSZ2401 specifications

The Zenoah PSZ2401 is a robust and efficient chainsaw designed for both professional and amateur use. Known for its reliability and performance, this model is particularly favored in the forestry industry, landscaping, and for residential purposes.

One of the main features of the Zenoah PSZ2401 is its lightweight design, which ensures easy handling and maneuverability. Weighing in at around 5.6 kg (approximately 12.3 lbs), it allows users to operate the chainsaw for extended periods without experiencing excessive fatigue. This is especially beneficial for professionals involved in tree trimming and logging operations, where prolonged use is common.

The PSZ2401 is powered by a high-performance Zenoah engine that delivers impressive cutting power. With a displacement of 24.0 cc, the engine combines efficiency with strong torque, making it capable of cutting through various types of wood with ease. Its air-cooled, two-stroke engine technology not only ensures optimal performance but also contributes to lower emissions, aligning with environmental standards.

Another standout feature is the automatic chain lubrication system. This technology maintains a consistent oil supply to the chain and bar, reducing wear and tear and extending the lifespan of the cutting components. Additionally, the tool-less chain tensioning system makes adjustments quick and straightforward, allowing users to achieve the desired tension without the need for extra tools.

The ergonomic design of the Zenoah PSZ2401 enhances user comfort. It features a wrap-around front handle and an anti-vibration system that minimizes shock during operation. This results in reduced operator fatigue, enabling longer periods of use while maintaining precision and control.

Safety is a critical aspect of the Zenoah PSZ2401, and it is equipped with several safety features. These include a chain brake system that stops the chain instantly in case of kickback and a throttle lockout that prevents accidental throttle engagement. These features provide peace of mind and contribute to safer operation in demanding environments.

Overall, the Zenoah PSZ2401 is a well-engineered chainsaw that excels in power, efficiency, and user-friendly design. Its combination of advanced technologies, durability, and safety features makes it an excellent choice for both novice users and seasoned professionals, ensuring that it remains a reliable tool in any cutting endeavor.
Top Page Image Contents