Zenoah MD6210M owner manual Storage, Disposal

Page 17

MD6210M

10. Storage

WARNING

When draining fuel, please be careful not to spill it. If fuel is spilt, wipe off thoroughly. In addition, please be sure to close the storage container cap tightly.

IMPORTANT

If fuel is left in the engine for protracted periods, the inside of the carburetor may become clogged and cause engine malfunction (faulty starting and insuffi- cient output).

During storage, slightly loosen the cap of the chemi- cal fluid tank. If screwed too tightly, the gasket may become distorted.

On completion of all work procedures, when not plan- ning to use again for a protracted period please carry out the following pre-storage care, to prevent trouble caused by time-lapse changes.

1.Clean the chemical fluid tank and nozzle.

2.Remove dirt from the sprayer, inspect it for any dam- age or looseness, and, if any abnormality is found, correct it thoroughly in preparation for the next time you use the unit.

3.Drain the fuel tank.

4.Start the engine, and leave it in idling condition until all the fuel inside the carburetor is spent and the en- gine comes to a natural stop.

5.Remove the spark plug and put a few drops (1 to 2 cc) of 2-cycle oil inside the engine. After pulling the starter rope 2 or 3 times, return the spark plugs to their original position and stop in compressed posi- tion.

6.After oiling the throttle lever and other metal parts with anti-corrosive oil, cover the sprayer and store unit in a dry, dust free place, out of the reach of children.

G B

11. Disposal

When you dispose of the machine, do not disassemble the machine.

Do not simply discard empty chemical containers, but dispose of them safely by incinerating, burying, or another similar method. In addition, please take ev- ery care that the water used to clean spraying tools does not create any hazard.

When disposing your machine, fuel or oil for the ma- chine, be sure to allow your local regulations

GB-17

Image 17
Contents GB-1 MD6210MMeasured Wear head, eye and ear protectionMD6210M 62.0 cm 107 dBA 108 dBA 102 dBA E13*97/68SH3G3*2002/88*0095*02Parts location ContentsSymbols on the ma- chine SpecificationModel MD6210MNever let a child under 13 years old use the machine For safe operationAlways follow the instructions Working ConditionAvoid Noise Problem Other PrecautionsWorking Circumstance Working PlanPrecautions When Transporting Chemicals Precautions Before SprayingPrecautions When TRANS- Porting the Sprayer FuelUsing the Product Precautions When Refilling ChemicalsGB-8 Tainer approved for flammable liq- uids ConditionDo not allow bystanders in work area MaintenanceStorage TransportationDisposal GB-10Solution Tube Set upFlexible Hose and Swivel Joint Control HandleFuel HOW to MIX FuelRecommended Mixing Ratio Gasoline 50 OIL Fueling the UnitHOW to USE Adjusting Idle SpeedOperation Control ARMHorizontal direction 12 m Vertical direction GB-14 AIR Cleaner MaintenanceCleaning AIR Filter Fuel FilterMuffler Procedures to be Performed After Every 100 Hours of USEAIR Inlet NET Shoulder StrapDisposal StorageLimited warranty Troubleshooting guideCase 1. Starting failure Check Probable Causes Action