Zenoah PSZ2600 ~ 2 mm, GB-11, Stopping Engine, Adjusting Throttle Cable, Adjusting Idling Speed

8. Operation

6.While holding the unit firmly, pull out the starter rope quickly until engine fires.

WARNING

The product is equipped with a centrifugal clutch mecha- nism, so the cutting attachment begins to rotate as soon as the engine is started by putting the throttle into the start position. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the engine starts.

PSZ2600

STOPPING ENGINE

G

B

1.Release the throttle lever and run the engine for half a minute.

2.Shift the ignition switch (a) to the STOP position.

IMPORTANT

•Except for an emergency, avoid stopping the engine while pulling the throttle lever.

ADJUSTING THROTTLE CABLE

•The normal play is 1 or 2 mm when measured at the carburetor side end. Readjust with the cable adjuster as required.

IMPORTANT

•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.

7.Move the choke lever downward to open the choke. And restart engine.

(1)

(2)

(3)

(1)Choke lever (2) Close (3) Open

8.Allow the engine to warm up for a several minutes before starting operation.

NOTE

1.When restarting the engine immediately after stopping it, leave the choke open.

2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.

1 ~ 2 mm
(0.04 in)	(1)

(1) Cable adjuster

ADJUSTING IDLING SPEED

(1)

(1)Idle adjusting screw

1.When the engine tends to stop frequently at idling mode, turn the adjusting screw clockwise.

2.When the cutting head keeps rotating after releasing the trig- ger, turn the adjusting screw counter-clockwise.

NOTE

• Warm up the engine before adjusting the idling speed.

GB-11