Zenoah HBZ2602 owner manual Working Circumstance, Avoid Noise Problem, Working Plan, Fuel

HB2302 / HBZ2602

5. For safe operation

8.The ignition system of your unit produces an electromagnetic field of a very low intensity. This field may interfere with some pacemakers. To reduce the risk of serious or fatal injury, persons with pacemaker should consult their physician and the pace- maker manufacturer before oper- ating this tool.

WORKING CIRCUMSTANCE

1.To reduce the risk of injury asso- ciated with exhaust fume inhala-

t i o n , d o n o t o p e r a t e i n unventilated area. The exhaust gases contain harmful carbon monoxide.

2.Avoid using the blower where stable footing and balance are not assured.

3.Never operate the machine in high wind, bad weather, poten- tially explosive atmosphere, when visibility is poor or in very high or low temperatures. (Our recom- mended use environment is be- low 40 degrees C (104 degrees F).)

AVOID NOISE PROBLEM

IMPORTANT

Check and follow the local regulations as to sound level and hours of operations for blower.

1.Operate power equipment only at reasonable hours-not early in the morning or late at night when people might be disturbed. Com- ply with times listed in local ordi- nances.

2.To reduce sound levels, limit the

number of pieces of equipment used at any one time.

3.Operate power blowers at the lowest possible throttle speed to do the job.

4.Check your equipment before op- eration, especially the muffler, air intakes and air filters.

WORKING PLAN

•When planning your work sched- ule, allow plenty of time to rest.

GB-6

Limit the amount of time over which the product is to be used continuously to somewhere around 30 ~ 40 minutes per ses- sion, and take 10 ~ 20 minutes of rest between work sessions. Also try to keep the total amount of work performed in a single day under 2 hours or less.

FUEL

WARNING

To reduce the risk of fire and burn injury:

a)Handle fuel with care. It is highly flammable.

b)Do not smoke while handing fuel.

c)Do not refuel a hot engine.

d)Do not refuel a running engine.

e)Avoid spilling fuel or oil. Always

wipe unit dry before using.

f ) Move at least 10 ft. (3 meters) away from the fueling point be- fore starting engine.

g)Always store gasoline in a con- tainer approved for flammable liq- uids.

h)Make sure the unit is properly as- sembled and in good operating condition.

i ) Do not use the blower near a fire, as aiming the blower in the direc- tion of a flame may cause flam- mable substances to ignite.

BEFORE STARTING THE ENGINE

•Each time before starting the en- gine, inspect the entire unit to see if every part is in good order and is securely tightened in place. If any damage is found in the fuel line, the exhaust line, or the igni- tion wiring, do not use the blower until it has been repaired.

IMPORTANT

•Before starting operation, al- ways make sure to check if any obstacles are left inside the volute case and net. The ob- stacles may cause damage on fan and volute case and serious injury.