BCZ2610DL
6. Set up
SUSPENSION POINT | SUSPENSION POINT |
NOTE |
|
Be the SUSPENSION POINT in the location of the arrow mark.
arrow mark
INSTALLING HANDLE
NOTE
The handle is put during the arrow mark.
• Mount the handle to | SPACING |
MIN | |
the shaft tube and |
|
suspension point it |
|
at a location that is | About 48 cm |
comfortable to you. |
HARNESS
WARNING
ALWAYS WEAR THE PROVIDED HARNESS WHEN USING THE MACHINE!
Always make sure the machine is hooked securely to the harness.
If you don't, you will be unable to control the machine safely. This can result in injury to yourself or others. Never use a harness with a defective quick release or any other damage.
HOW TO WEAR
1.Wear the provided harness without twisted bands, with the hanger on your right side.
INSTALLING CUTTING ATTACHMENT GUARD FOR LINE HEAD
• Attach the cutting attachment guard with the bolts provided while inserting the spacer between the guard and the pipe.
INSTALLING LINE HEAD
1.While locking the gear shaft by inserting the angled bar(1) into the holder(A)(2) on the angle transmission, loosen and remove the nut
2.Fit the line head assembly to the gear shaft. Tighten it securely by hand.
INSTALLING CUTTING ATTACHMENT GUARD FOR METAL BLADE
•When using metal blade, make sure to remove the guard skirt.
BLADE
1.Put the angled bar(1) into the side holes of the holder(A)(2) and the angle transmission.
2.Remove the nut
3.Put the blade onto the holder(A)(2). Make the marked side face the holder.
4.Put the holder(B)(3) onto the gear shaft making the recessed side face the blade.
5.Fasten the blade by the nut and the cover(4).
(1) Hanger
(1)
BALANCE THE UNIT
1.Hook your machine to the hanger.
2.Adjust the bands of the harness to have the blade parallel to the ground when standing in your normal working position to provide you most effectiveness and comfort on operating the machine.
3.In order to prevent the hanger position to change during operation, turn up the extra part of the band from the buckle.
4.When correctly adjusted, check the correct working of the harnesses'
QUICK RELEASE.
QUICK RELEASE
The harness is equipped with a "QUICK RELEASE"devise. To release the machine from the harness in emergency situations, please follow the procedure as explained below.
WARNING
Make sure to check proper working of the QUICK RE- LEASE device BEFORE operating the machine. Make sure to hold the unit securely when using the
QUICK RELEASE.
While holding the unit by your right hand securely, press both sides of the buckle. sides of the buckle.
(1) Buckle
(1)