Zenoah BK3410FL, BK4310FL SE5 SE6, Attaching the Throttle Cable, Band Throttle cable Tie loosely

Page 10

SE5

SE6

4. SET UP

try inserting it again.

•Once the liner has been inserted, pull on the liner to make sure that the stopper is properly engaged.

■ATTACHING THE THROTTLE CABLE

WARNING

After fitting the wire, check if the wire sleeve is correctly fitted to the wire stopper. It is dangerous if the wire sleeve is out of the wire stopper because the engine speed will not decrease even if the throttle lever is released.

•Align the throttle cable along with the liner and tie it with band. (SE5)

(1)Band

(2)Throttle cable

(3)Tie loosely

1.Hook the cable and into the hole of the throttle lever. And set the cable in the lever as shown in the picture. (SE6)

2.Attach the lever as shown in the picture and screw it securely. (SE6)

(1)Throttle lever

(2)Hole

(3)Throttle cable

(4)Screw

(5)Nut

Image 10

Contents BK3410FL BK4310FL Contents Position AIR Cleaner Cover Symbols on the MachinePosition Fuel Tank CAP Safety Precautions Before Using the MachineWorking Gear and Clothing Things to Check Before Using Your Brushcutter Kickback Safety Precautions Operation Safety PrecautionsMaintenance Safety Precaution Attaching the Shoulder Strap SE1 SET UPSE1 SE2 SE3 SE4 Upper Side Lower SideBand Throttle cable Tie loosely SE5 SE6Attaching the Throttle Cable Throttle lever Hole Throttle cable Screw NutAttaching the Handle Adjusting Throttle CableSE7 SE8 SE9 Attaching the Debris GuardBar Holder B Holder a SE10 SE11Blade Tightening torque 14.7~19.6 N-m/150~200kgf-mFuel Mixing ratiosOP2 OP3 OP4 OperationStarting the Engine Equipping the Shoulder Strap OP6 OP5 OP6 OP7Stopping the Engine Cutting OperationOP8 Adjusting the Line LengthLine Head Usage MA1 MA2 MA3 MaintenanceAfter 25 Hours of USE AIR Cleaner Refilling Trimming Line MA2Fuel Strainer MA4 MA5 MA6MA7 Gear Case Spark PlugMaintenance Before Storage MA12 Adjusting CarburetorIdle Adjustment Screw MA11 MA8 MA9Storage SpecificationsDisposal