Zenoah BK3410FL, BK4310FL owner manual SE10 SE11, Blade, Bar Holder B Holder a, Line Head SE11

Page 12

SE10

SE11

4. SET UP

■BLADE

WARNING

•Never attach nor remove a cutting blade while the engine is running.

•Use ZENOAH genuine cutting blade for exchange.

•Wear sturdy gloves for attaching/removing a metallic cutting blade to avoid injury.

1.Loosen the nut, remove holder A and holder B from the gear case. (SE10)

(Note that this is a left-turning screw.)

(1)Bar

(2)Holder B

(3)Holder A

2.Attach the cover (SE11,(11)) and fix it with screw.

3.Insert blade between cutter holder A and cutter holder B. (SE11)

4.Attach cover and spring washer. (SE11)

5.Screw the bolt to fix them into place. (SE11)

Tightening torque:

14.7~19.6 N-m/150~200kgf-m

■LINE HEAD (SE11)

1.Detach bolt (1), spring washer (2), washer(3), bolt cover (4) and cover (11).

2.Put holder B (5) to holder A (9). Screw arbor bolt (12) in holder B (5).

3.Then attach the cutting head to the gear shaft over the holders. Hard-tighten it securely.

(1)Bolt

(2)Spring Washer

(3)Washer

(4)Bolt cover

(5)Holder B

(6)Blade

(7)Gear shaft

(8)Bar

(9)Holder A

(10)Gear case

(11)Cover preventing grass from getting caught up

(12)Arbor bolt

12

Image 12

Contents BK3410FL BK4310FL Contents Symbols on the Machine Position AIR Cleaner CoverPosition Fuel Tank CAP Safety Precautions Before Using the MachineWorking Gear and Clothing Things to Check Before Using Your Brushcutter Kickback Safety Precautions Operation Safety PrecautionsMaintenance Safety Precaution SET UP SE1 SE2 SE3 SE4Attaching the Shoulder Strap SE1 Upper Side Lower SideSE5 SE6 Attaching the Throttle CableBand Throttle cable Tie loosely Throttle lever Hole Throttle cable Screw NutAdjusting Throttle Cable SE7 SE8 SE9Attaching the Handle Attaching the Debris GuardSE10 SE11 BladeBar Holder B Holder a Tightening torque 14.7~19.6 N-m/150~200kgf-mFuel Mixing ratiosOperation OP2 OP3 OP4Starting the Engine OP5 OP6 OP7 Stopping the EngineEquipping the Shoulder Strap OP6 Cutting OperationAdjusting the Line Length OP8Line Head Usage Maintenance After 25 Hours of USE AIR CleanerMA1 MA2 MA3 Refilling Trimming Line MA2MA4 MA5 MA6 MA7 Gear CaseFuel Strainer Spark PlugAdjusting Carburetor Idle Adjustment Screw MA11Maintenance Before Storage MA12 MA8 MA9Specifications StorageDisposal