Zenoah BK4310FL, BK3410FL owner manual SE7 SE8 SE9, Adjusting Throttle Cable, Attaching the Handle

Page 11

SE7

SE8

SE9

4. SET UP

■ADJUSTING THROTTLE CABLE

•Proper play of the throttle cable is 1–2mm. Place the throttle lever to the lowest speed position (i.e. fully released status). Pull the throttle cable lightly with fingers to check its play. Readjust the position of cable adjuster if the play is too large or too small. To readjust, slacken a lock nut. Turn the cable adjuster clockwise to increase the play, or counterclockwise to decrease the play. Lock the cable adjuster with the lock nut after readjustment. (SE7)

(1)Cable adjuster

(2)Lock nut

(3)Throttle cable

■ATTACHING THE HANDLE

•Attach the loop handle as shown in the accompanying diagram. Note that it is recommended that you attach the handle so that the handle is located some 30–40cm away from the front end of the right-hand grip. (SE8)

(1)Loop handle

(2)Screw

(3)Washer

(4)Nut

■ATTACHING THE DEBRIS GUARD

WARNING

Never use the machine without the debris guard.

•Attach the guard to the clamp on the outer pipe just touching the gearcase. Fix it with 2 bolts. (SE9)

(1)Bolt (M5x25)

(2)Clamp

(3)Debris guard

(4)Place to be attached for blade use

(5)Place to be attached for line head

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents BK3410FL BK4310FL Contents Position Fuel Tank CAP Symbols on the MachinePosition AIR Cleaner Cover Before Using the Machine Safety PrecautionsWorking Gear and Clothing Things to Check Before Using Your Brushcutter Operation Safety Precautions Kickback Safety PrecautionsMaintenance Safety Precaution Upper Side Lower Side SET UPSE1 SE2 SE3 SE4 Attaching the Shoulder Strap SE1Throttle lever Hole Throttle cable Screw Nut SE5 SE6Attaching the Throttle Cable Band Throttle cable Tie looselyAttaching the Debris Guard Adjusting Throttle CableSE7 SE8 SE9 Attaching the HandleTightening torque 14.7~19.6 N-m/150~200kgf-m SE10 SE11Blade Bar Holder B Holder aMixing ratios FuelStarting the Engine OperationOP2 OP3 OP4 Cutting Operation OP5 OP6 OP7Stopping the Engine Equipping the Shoulder Strap OP6Line Head Usage Adjusting the Line LengthOP8 Refilling Trimming Line MA2 MaintenanceAfter 25 Hours of USE AIR Cleaner MA1 MA2 MA3Spark Plug MA4 MA5 MA6MA7 Gear Case Fuel StrainerMA8 MA9 Adjusting CarburetorIdle Adjustment Screw MA11 Maintenance Before Storage MA12Disposal SpecificationsStorage
Top Page Image Contents