Zenoah BK3410FL, BK4310FL owner manual Operation, OP2 OP3 OP4, Starting the Engine

Page 14

OP1 (1)

(2)

OP2

1. Pour the fuel and fasten the fuel cap. (OP1)

IMPORTANT

•Make sure that the cap is firmly shut and there is no fuel leak.

•Wipe out the spilled fuel.

2.Open the fuel cock. (OP2)

3.Move the choke lever to the closed position. (OP2)

(5)Close

(6)Open

NOTE

When restarting immediately after stopping the engine, move the choke lever to the open position.

4. Set the throttle lever to the starting position. (OP3)

NOTE

When restarting immediately after stopping the engine, move the throttle lever to the idling position.

5.While holding the unit firmly, pull out the starter rope quickly. (OP4)

6.After the engine has started, open the choke gradually.

7.Allow the engine to run for 2 to 3 minutes to warm up.

Image 14

Contents BK3410FL BK4310FL Contents Position Fuel Tank CAP Symbols on the MachinePosition AIR Cleaner Cover Safety Precautions Before Using the MachineWorking Gear and Clothing Things to Check Before Using Your Brushcutter Kickback Safety Precautions Operation Safety PrecautionsMaintenance Safety Precaution Attaching the Shoulder Strap SE1 SET UPSE1 SE2 SE3 SE4 Upper Side Lower SideBand Throttle cable Tie loosely SE5 SE6Attaching the Throttle Cable Throttle lever Hole Throttle cable Screw NutAttaching the Handle Adjusting Throttle CableSE7 SE8 SE9 Attaching the Debris GuardBar Holder B Holder a SE10 SE11Blade Tightening torque 14.7~19.6 N-m/150~200kgf-mFuel Mixing ratiosStarting the Engine OperationOP2 OP3 OP4 Equipping the Shoulder Strap OP6 OP5 OP6 OP7Stopping the Engine Cutting OperationLine Head Usage Adjusting the Line LengthOP8 MA1 MA2 MA3 MaintenanceAfter 25 Hours of USE AIR Cleaner Refilling Trimming Line MA2Fuel Strainer MA4 MA5 MA6MA7 Gear Case Spark PlugMaintenance Before Storage MA12 Adjusting CarburetorIdle Adjustment Screw MA11 MA8 MA9Disposal SpecificationsStorage