5. Set up
WARNING
•Assemble each part correctly. Wrong assembly might cause an accident.
•If you cannot do the assembling yourself, consult the shop where you bought this product.
insert the liner into the clutch housing, being careful to make sure that the hole on the end of the liner is facing directly upwards. When the hole reaches a point directly below the stopper, you will hear a clicking sound as the stopper moves into the hole to fix the liner into place. (SE4)
■ATTACHING THE SHOULDER STRAP (SE1)
1. Pass the ring of the shoulder strap through the hook(A) and fix it by the bolt securely.
2. Set the hook(B) of each shoulder strap to the
SE4
(1) Clutch housing
(2) Stopper
(3) Angular hole
(4) Hole
(5) Liner
SE1
■ATTACHING THE LINER
(A)UPPER SIDE
(B)LOWER SIDE
(1) Hook (A)
(2) Bolt (M5x12)
(3) Hook (B)
(4) D-ring
•If you experience any difficulty in inserting the liner, pull out the liner, rotate the flexible shaft slightly, and try inserting it again.
•Once the liner has been inserted, pull on the liner to make sure that the stopper is properly engaged.
IMPORTANT
After connecting the inner shaft to the shaft of the main
1.Remove the bolt located on the joint of the outer pipe. (SE2)
2.Match the groove of the liner with the threaded hole and fix with screw securely. (SE2)
SE2
(1) Bolt
(2) Joint
(3) Groove
pipe, try to pull out the flexible shaft by hand to make sure the flexible shaft does not come off.
■ATTACHING THE THROTTLE CABLE
WARNING
After fitting the wire, check if the wire sleeve is correctly fitted to the wire stopper. It is dangerous if the wire sleeve is out of the wire stopper because the engine speed will not decrease even if the throttle lever is released.
3.While rotating the flexible shaft located on the opposite end from the liner, insert the flexible shaft into the joint until it is tightly connected. (Note that it is normal at this time for the flexible shaft not to project from the liner.) (SE3)
SE3
(1) Flexible shaft
(2) Liner
(3) Clutch housing
•Align the throttle cable along with the liner and tie it with band. (SE5)
SE5
(1) Band
(2) Throttle cable
(3) Tie loosely
4.To connect the clutch housing to the liner, lay the liner out straight, align the flexible shaft with the angular hole on the side of the clutch drum, and
1.Hook the cable and into the hole of the throttle lever. And set the cable in the lever as shown in the picture. (SE6)
9