Zenoah BK4310FL-S OP2, Stopping the Engine, OP3, OP5, OP4, Equipping the Shoulder Strap OP6

Page 14

7. Operation

position and pull out the starter rope repeatedly, or try the starting operation again after removing the spark plug and drying the electrode.

1.Open the fuel cock. (OP2)

2.Move the choke lever to the closed position. (OP2)

IMPORTANT

Do not pull out the starter rope up to its end, and do not let the knob jump out of the right hand otherwise it may not return to its original position.

OP2

NOTE

(1)Fuel cock

(2)Close

(3)Open

(4)Choke lever

(5)Close

(6)Open

5.After the engine has started, open the choke gradually.

6.Allow the engine to run for 2 to 3 minutes to warm up.

STOPPING THE ENGINE

WARNING

• Stop the engine immediately in an emergency.

• The blade rotates by inertia for a while after the

engine has stopped. Do not touch the blade until the

engine has stopped completely.

• Do not touch the muffler or spark plug with bare

hands immediately after the engines has stopped.

Otherwise you may suffer burns because the muffler

When restarting immediately after stopping the engine, move the choke lever to the open position.

3. Set the throttle lever to the idling position. (OP3)

and spark plug are extremely hot.

1.Return the throttle lever to the idling position.

2.Push the engine switch button. (OP5)

3.Close the fuel cock.

OP3

NOTE

(1)Idling

(2)Full throttle

OP5

(1) Engine switch button

When restarting immediately after stopping the engine, move the throttle lever to the idling position.

4.Place the machine on a flat and firm place, and make sure to keep the blade clear of everything around it. Then, holding the main pipe with your left hand, put your right foot on the frame, and pull out the starter knob with your right hand quickly. (OP4)

OP4

IMPORTANT

If you stop the engine while keeping the revolution speed high, the engine could become damaged. Return the throttle lever to its original position and reduce the engine speed before stopping the engine except in an emergency.

EQUIPPING THE SHOULDER STRAP (OP6)

1.Hold the main pipe with your right hand. Hang the left strap on your left shoulder.

2.Change your hand to hold the main pipe with your left hand. Hang the right strap on your right shoulder.

14

Image 14
Contents BK3410FL / BK3410FL-S Contents 15m 50ft Position AIR Cleaner Cover Symbols on the machineSpecifications Position Fuel Tank CAPWorking Circumstance Safety precautionsWorking Condition Working PlanStarting the Engine Using the ProductBefore Starting the Engine Handling Fuel MaintenanceIf Someone Comes TransportationHow you can reduce the chance of blade thrust How you can maintain the best controlSet up SE8 Adjusting Throttle CableSE6 Attaching the Debris GuardSE12 Rotating direction SE10 Bar Holder B Holder aSE13 Arbor bolt Holder B Holder a Fuel Mixing ratiosOP1 OperationRefueling Tank capOP3 OP2Stopping the Engine OP5Blade Usage OP7 OP6 OP8Cutting Operation OP7Adjusting the Line Length MA1 Refilling Trimming Line MA2 MaintenanceAIR Cleaner MA2AIR Cooling Vent Fuel FilterMA5 MA4MA7 Maintenance Every 100 HoursAdjusting the Engine Flexible ShaftMaintenance Before LONG-TERM Storage MA12 Tank cap Fuel tankTrouble shooting DisposalLimited warranty Warranty does not Apply to ThosePage Zenoah